Renault Clio: Front left-hand wiring: Connector access

I - LOCATION OF CONNECTORS

• Connection R 107 (front left-hand wiring/dashboard wiring connection) composed of two to four connectors depending on equipment.

• R 374 connector (front left-hand wiring/rear left-hand wiring connection).

• Connection R 67 (front left-hand wiring/engine wiring harness connection) composed of two to three connectors depending on equipment.

• R 33 connector (front left-hand wiring/front bumper wiring connection).

II - ACCESS TO CONNECTORS

IMPORTANT

Consult the safety and cleanliness advice and operation recommendations before carrying out any repair (see 88A, Wiring harness, Wiring: Precautions for the repair, 88A-5).

WARNING

To prevent damaging the connectors, consult the disconnection procedure (see Connector: Disconnection and reconnection) (Technical Note 6015A, 88A, Wiring).

• Switch off the ignition.
• Disconnect the battery (see 80A, Battery, Battery: Removal - Refitting, 80A-1).

1 - Access to the R 107 connectors

LEFT-HAND DRIVE

• Remove the dashboard side face (1).

• Remove:
  • the dashboard trim piece (2),
  • the dashboard lower trim bolt (3).

• Remove:
  • the dashboard lower trim bolt (4).
  • the dashboard lower trim.

• Disconnect the connectors from connection R 107.

RIGHT-HAND DRIVE

• Remove the glovebox (see Glovebox: Removal - Refitting) (MR 393, 57A, Interior equipment).

• Disconnect the connectors from connection R 107.

2 - Access to the R 374 connector

• Remove the front left-hand door sill lining (see Front door sill lining: Removal - Refitting) (MR 393, 71A, Body internal trim).

• Disconnect the R 374 connector.

3 - Access to the R 67 connector

• Remove:
  • the bolts (5) from the Protection and Switching Unit cover,
  • the Protection and Switching Unit cover.

• Disconnect the connectors from connection R 67.

4 - Access to the R 33 connector

• Remove the front section of the front left-hand wheel arch liner (see Front wheel arch liner: Removal - Refitting) (MR 393, 55A, Exterior protection).

• Disconnect the R 33 connector.

READ NEXT: