Renault Clio: Drive plate: Removal - Refitting

K4M, and DP0

REMOVAL

I - REMOVAL PREPARATION OPERATION

• Remove the gearbox (see 23A, Automatic gearbox, Automatic gearbox: Removal - Refitting, 23A-7).

II - OPERATION FOR REMOVAL OF PART CONCERNED

• Set up the (Mot. 582-01) (2).
• Remove:
  • the bolts (2),
  • the drive plate,
  • tool (Mot. 582-01).

REFITTING

I - REFITTING PREPARATIONS OPERATION

• Check that the drive plate is not damaged (run-out tolerance of 0.2 mm on the outer diameter).

II - REFITTING OPERATION FOR PART CONCERNED

• Fit the drive plate, ensuring it is correctly positioned in relation to the centring pins.
• Apply LOCTITE FRENBLOC to the bolt threads.
• Tighten the bolts on the drive plate.
• Torque and angle tighten the drive plate bolts (55 Nm + 50

  READ NEXT:

   Multifunction switch: Removal - Refitting

  DP0 REMOVAL I - REMOVAL PREPARATION OPERATION Shift the selector lever to Neutral. Disconnect the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery). Remove the battery tray (se

   Speed sensor: Removal - Refitting

  DP0 Do not drain or remove the automatic gearbox in order to remove the speed sensor. The output speed sensor has been deleted and replaced with wheel speed sensors. REMOVAL I - REMOVAL PREPARATION

   Pressure sensor: Removal - Refitting

  DP0 REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on the two-post lift (see 02A, Lifting equipment, Vehicle: Towing and lifting). Disconnect the battery (see 80A, Battery, Batter

  SEE MORE:

    Engine cooling system: Check

  IMPORTANT When working in the engine compartment, take care as the radiator fan(s) may start up unexpectedly (risk of being cut). To avoid any risk of serious burns when the engine is hot: do not open the expansion bottle cap, do not drain the cooling system, do not open the bleed screw(s). N

    Engine cooling system: Operating diagram

  D4F D4F, and 740 or 742 or 764 Engine Cooling radiator heater matrix Expansion bottle Water pump Thermostat Bleed screws 5 mm restriction 10 mm restriction Note: The rating of the expansion bottle degassing valve is 1.4 bar. D4F, and 784 Engine Cooling radiator Heater matrix Expans