Renault Clio: Drive plate: Removal - Refitting

K4M, and DP0

REMOVAL

I - REMOVAL PREPARATION OPERATION

• Remove the gearbox (see Automatic gearbox: Removal - Refitting).

II - OPERATION FOR REMOVAL OF PART CONCERNED

• Set up the (Mot. 582-01) (2).
• Remove:
  • the bolts (2),
  • the drive plate,
  • tool (Mot. 582-01).

REFITTING

I - REFITTING PREPARATIONS OPERATION

• Check that the drive plate is not damaged (run-out tolerance of 0.2 mm on the outer diameter).

II - REFITTING OPERATION FOR PART CONCERNED

• Fit the drive plate, ensuring it is correctly positioned in relation to the centring pins.
• Apply LOCTITE FRENBLOC to the bolt threads.
• Tighten the bolts on the drive plate.
• Torque and angle tighten the drive plate bolts (55 Nm + 50

  READ NEXT:

   Top And Front Of Engine

   Pressure at end of compression: Check

  K9K Remove the heater plugs (see 13C, Preheating, Heater plugs: Removal - Refitting, 13C-2). Disconnect: the pressure regulation solenoid valve connector (1), the flow control solenoid val

   Accessories belt: Removal - Refitting

  K4J, and STANDARD HEATING - K4M, and STANDARD HEATING REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (02A, Lifting equipment).

  SEE MORE:

    B-pillar upper trim: Removal - Refitting

  C85 REMOVAL REMOVAL PREPARATION OPERATION Remove: the complete rear bench seat, the rear wing panel lining (see 71A, Body internal trim, Rear panel lining: Removal - Refitting, 71A-32). Remove: the bolt (1), the seat belt. Unclip the height adjustment device (2). Rem

    B-pillar trim: Removal - Refitting

  B85 REMOVAL I - REMOVAL PREPARATION OPERATION Move the seats fully forward. Partially remove the frame seals (1). Partially unclip the front and rear door sill trims. II - REMOVAL OF PART CONCERNED Unclip the B-pillar lower trim at (2). Remove the B-pillar lower trim. Unclip bolt c