Renault Clio: B-pillar trim: Removal - Refitting
B85

REMOVAL
I - REMOVAL PREPARATION OPERATION

- Move the seats fully forward.
- Partially remove the frame seals (1).
- Partially unclip the front and rear door sill trims.
II - REMOVAL OF PART CONCERNED

- Unclip the B-pillar lower trim at (2).

- Remove the B-pillar lower trim.

- Unclip bolt cover.
- Remove the bolt (3).

- Use a flat-blade screwdriver to unclip the height adjustment control
(4).

- Unclip (5) the B-pillar upper trim (6).

REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
- Reclip:
- the B-pillar upper trim,
- the height adjustment device.
- Torque tighten the seat belt bolt (21 Nm).
- Reattach the B-pillar lower trim.
II - FINAL OPERATION.
- Refit the front and rear door sill trims.
- Refit the frame seals.
READ NEXT:
B85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the complete rear bench seat.
Partially remove seal (1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Remove the trim at (2) and at (3).
C85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the rear wing panel lining (see 71A, Body internal
trim, Rear panel lining: Removal - Refitting, 71A-32),
the rear roof drip moulding lini
IMPORTANT
Consult the safety and cleanliness advice and operation
recommendations before carrying out any
repair (see Airbag and pretensioners: Precautions
for the repair) (88C, Airbags and pretensio
SEE MORE:
DP0
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Shift the selector lever to Neutral.
Disconnect the battery (see Battery: Removal - Refitting)
(MR 392, 80A, Battery).
Remove:
the front
Rear axle assembly: Adjustment values
EQUIPMENT LEVEL E3 LEISURE or EQUIPMENT LEVEL EA1 or EQUIPMENT LEVEL EA2
or EQUIPMENT
LEVEL EA3 or EQUIPMENT LEVEL EA4 or EQUIPMENT LEVEL EA5 or EQUIPMENT LEVEL EAG
I - PRELIMINARY OPERATIONS
Before checking the axles on the test bench, check the
tyre press
© 2016-2025 Copyright Renault Clio Owners Club
