Renault Clio: To lock the system

Renault Clio. To lock the system


NB: if the tool kit does not lock in place, check the tightness of nut 3 and the correct positioning of handle 4.

Special features

The emergency spare wheel holder should always be present when you are driving even when the wheel itself is not present: risk of water entering the vehicle.

If you have to release it when it is not holding a wheel, push the centre of the wheel holder towards the ground while pressing handle 4.

It is essential to lock the nut so that the wheel is held securely.

The system should only be used with the original vehicle wheels or identical wheels.

READ NEXT:

 Tyre inflation kit

The kit repairs tyres when tread A has been damaged by objects smaller than 4 mm. It cannot repair all types of puncture, such as cuts larger than 4 mm, or cuts in tyre si

 Tools

The tools included in the tool kit depend on the vehicle. Tool kit A is located in the tray under the luggage compartment carpet. Lift the cover and remove it. Wheelbrace 1 Locks or

 Wheel trims - wheel

Remove the wheel trim using hubcap tool 1 (located in the tool kit) by engaging the hook in the opening near valve 2. To refit it, align it with valve 2. Push the retaining hooks in fully,

SEE MORE:

 Rear air distribution duct: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Lock the airbag computer using the Diagnostic tool (see Fault finding - Replacement of components) (MR 394, 88C, Airbags and pretensioners). Disconnect the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery). Remove the centre console (

 Injector leak flow: Check

K9K, and 750 or 752 or 764 or 766 or 768 Note: Vehicles equipped with the K9K*768 engine may or may not be equipped with an intercooler. Disconnect the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery). Disconnect the inlet pressure sensor (1). Remove the air duct (3) betwee

© 2016-2025 Copyright Renault Clio Owners Club