DP0

The automatic transmission series number can be found in two places: on a label on the hydraulic distributor cover (1) and etched onto the outer casing (2) on the wheel side.
Automatic gearbox oil: Draining - Filling
DP0

I - OIL SERVICE
Note:
Drain the automatic transmission oil when the oil
is warm (60READ NEXT:
K4M, and DP0
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
Remove:
the engine undertray,
the fr
Automatic gearbox: Removal - Refitting
K4M, and DP0
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the gearbox (see 23A, Automatic gearbox,
Automatic gearbox: Removal - Refitting, 23A-7).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Drive plate: Removal - Refitting
DP0
REMOVAL
I - REMOVAL PREPARATION OPERATION
Shift the selector lever to Neutral.
Disconnect the battery (see Battery: Removal - Refitting)
(MR 392, 80A, Battery).
Remove
the battery tray (se
Multifunction switch: Removal - Refitting
SEE MORE:
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the scuttle panel grille (see 56A, Exterior
equipment, Scuttle panel grille: Removal - Refitting, 56A-1).
Remove the trim under the scuttle panel grille (1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Remove:
the bolts (2),
the blanki
Scoop under the scuttle panel grille: Removal - Refitting
IMPORTANT
Use a repair bench to ensure the positioning of the
points and the geometry of the axle assemblies.
Note:
The information contained in the following
describes the general repair procedure for all vehicles
having the same design for this part.
Before reading this general information, check
Engine stand: General description