Renault Clio: Charge circuit: Specifications

Renault Clio III (2005-2013) Service Manual / Engine And Peripherals / Starting - Charging / Charge circuit: Specifications

D4F or F4R or K4J or K4M or K9K or M4R

ALTERNATOR SPECIFICATIONS

Renault Clio. Charge circuit: Specifications

Charge circuit: Function

D4F or F4R or K4J or K4M or K9K or M4R

OPERATION

These vehicles are fitted with a built-in regulator and an instrument panel warning light which operates as follows:

when the ignition is switched on, the warning light comes on,
the warning light goes out when the vehicle is started,
if the warning light comes on while the engine is running, it indicates a battery charge fault.

Charge circuit: Check

D4F or F4R or K4J or K4M or K9K or M4R

Check the current after 30 minutes of heating at a voltage of 13.5 V.

Renault Clio. Charge circuit: Check

SEE MORE:

K9K, and 766 or 768

REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Disconnect the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery). Remove: the engine cover, the air inlet duct, the front

Operating faults

The following advice will enable you to carry out quick, temporary repairs. For safety reasons you should always contact an approved Dealer as soon as possible. Using the RENAULT card POSSIBLE CAUSES WHAT TO DO The RENAULT card does not lock or unlock the doo

Renault Clio: Charge circuit: Specifications

READ NEXT:

Alternator: Removal - Refitting

Starter: Removal - Refitting

Ignition

SEE MORE:

K9K, and 766 or 768

Operating faults