Renault Clio: To lock the system

Renault Clio. To lock the system


NB: if the tool kit does not lock in place, check the tightness of nut 3 and the correct positioning of handle 4.

Special features

The emergency spare wheel holder should always be present when you are driving even when the wheel itself is not present: risk of water entering the vehicle.

If you have to release it when it is not holding a wheel, push the centre of the wheel holder towards the ground while pressing handle 4.

It is essential to lock the nut so that the wheel is held securely.

The system should only be used with the original vehicle wheels or identical wheels.

READ NEXT:

 Tyre inflation kit

The kit repairs tyres when tread A has been damaged by objects smaller than 4 mm. It cannot repair all types of puncture, such as cuts larger than 4 mm, or cuts in tyre si

 Tools

The tools included in the tool kit depend on the vehicle. Tool kit A is located in the tray under the luggage compartment carpet. Lift the cover and remove it. Wheelbrace 1 Locks or

 Wheel trims - wheel

Remove the wheel trim using hubcap tool 1 (located in the tool kit) by engaging the hook in the opening near valve 2. To refit it, align it with valve 2. Push the retaining hooks in fully,

SEE MORE:

 Parking sensor

Operating principle Ultrasonic detectors, installed in the rear bumper (depending on the vehicle), measure the distance between the vehicle and an obstacle whilst reversing. This measurement is indicated by beeps which become more frequent the closer you come to the obstacle, until they be

 Rear bumper wiring: Connector access

I - LOCATION OF CONNECTORS R 319 connecter (rear bumper/rear connection). II - ACCESS TO CONNECTORS IMPORTANT Consult the safety and cleanliness advice and operation recommendations before carrying out any repair (see 88A, Wiring harness, Wiring: Precautions for the repair, 88A-5). WARNING To pr

© 2016-2025 Copyright Renault Clio Owners Club