Renault Clio: Charge circuit: Specifications
Renault Clio III (2005-2013) Service Manual / Engine And Peripherals / Starting - Charging / Charge circuit: Specifications
D4F or F4R or K4J or K4M or K9K or M4R
ALTERNATOR SPECIFICATIONS
Charge circuit: Function
D4F or F4R or K4J or K4M or K9K or M4R
OPERATION
These vehicles are fitted with a built-in regulator and an instrument panel warning light which operates as follows:
- when the ignition is switched on, the warning light comes on,
- the warning light goes out when the vehicle is started,
- if the warning light comes on while the engine is running, it indicates a battery charge fault.
Charge circuit: Check
D4F or F4R or K4J or K4M or K9K or M4R
Check the current after 30 minutes of heating at a voltage of 13.5 V.
READ NEXT:
Alternator: Removal - Refitting
K4J, and STANDARD HEATING - K4M, and STANDARD HEATING
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle: Towing and
lifting).
Remove the air inlet
Starter: Removal - Refitting
D4F, and 740 or 742 or 764
REMOVAL
I - REMOVAL PREPARATION OPERATION
Disconnect the battery (see Battery: Removal - Refitting)
(MR 392, 80A, Battery).
Remove the air filter unit (see 12A, Fuel mi
SEE MORE:
Anti-lock braking system
(ABS)
Under heavy braking, the ABS prevents
the wheels from locking, allowing the
stopping distance to be managed and
keeping control of the vehicle.
Under these circumstances, the vehicle
can be steered to avoid an obstacle
whilst braking. In addition, this system
can increase stopping distances
Conrod bearing shell:
Removal - Refitting
K9K
IMPORTANT To avoid all risk of damage to the systems, apply the
safety and cleanliness instructions and operation recommendations before
carrying out any repair (see Vehicle: Precautions for the repair).
IMPORTANT Wear leaktight gloves (Nitrile type) for this operation.
REMOVAL
I - REMOVAL PR
© 2016-2025 Copyright Renault Clio Owners Club
