Renault Clio: Rear fog lights: Removal - Refitting

REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED
K85, and DOCUMENTATION PHASE 1

- Move the rear fog light using the tool (Car. 1363) as a lever at (1).
B85 or C85 or S85, and DOCUMENTATION
PHASE 2

- Move the rear fog light using the tool (Car. 1363) as a lever at (2).
- Disconnect the rear fog light connector.
- Remove the rear fog light.
REFITTING
I - REFITTING PREPARATION OPERATION
K85, and DOCUMENTATION PHASE 1

- If the indicator light bulb needs replacing, remove:
- the bulb holder (3) by turning it forty-five degrees
counter-clockwise,
- the bulb from the bulb holder.
B85 or C85 or S85, and DOCUMENTATION
PHASE 2

- If the indicator light bulb needs replacing, remove:
- the bulb holder (4) by turning it forty-five degrees
counter-clockwise,
- the bulb from the bulb holder.
- When replacing a bulb, use an approved bulb.
II - REFITTING OPERATION FOR PART
CONCERNED
- Refit:
- the bulb on the bulb holder,
- the bulb holder by turning it forty-five degrees
clockwise.
- Connect the rear fog light connector.
- Clip the fog light onto the rear bumper.
Number plate light: Removal - Refitting
REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED

- Remove the licence plate light using a flat-blade
screwdriver.
- Disconnect the connector.

- Unclip the light at (1) to gain access to the bulb.
REFITTING
REFITTING OPERATION FOR PART CONCERNED
- When replacing a bulb, use an approved bulb.

- Connect the connector.
- Refit the light.
READ NEXT:
Interior lighting: Function
I - GENERAL INFORMATION
Vehicles may be fitted with the following units for lighting
the interior of the passenger compartment, depending
on the level of equipment:
a cou
Fuses: List and location of components
Passenger compartment fuse and
relay box
Consumer cut-out fuse
Additional relay/fuse box
Battery protection fuses
Protection and switching unit
Power sup
SEE MORE:
B85 or K85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the door trim (see Rear side door trim:
Removal - Refitting) (MR 393, 72A, Side opening
element trim).
Unclip the access blanking cover at the locking bolt
of the dummy lock.
Loosen the locking bolt completely without removing
i
D4F, and 740
WARNING
Do not use any product designed to improve electrical
contact in the injection computer connectors
and oxygen sensors and on the oxygen sensor
body. Failure to respect this advice prevents the
oxygen sensor from operating correctly and results
in failure to comply with the emis
© 2016-2025 Copyright Renault Clio Owners Club
