Renault Clio: Scuttle panel grille: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove the wiper arms (see Windscreen wiper
arm: Removal - Refitting) (MR 392, Mechanical
systems, 85A, Washing - Wiping).

II - OPERATION FOR REMOVAL OF PART
CONCERNED


- Remove the scuttle panel grille (3) and (4).
REFITTING
I - REFITTING PREPARATION OPERATION
Note:
Check that the windscreen and the scuttle panel
grille are clean before refitting.
II - REFITTING OPERATION FOR PART
CONCERNED

- Refit:
- the scuttle panel grille,
- the clips (5).
III - FINAL OPERATION.

- Refit:
- the seal (6),
- the wiper arms (see Windscreen wiper arm: Removal
- Refitting) (MR 392, Mechanical systems,
85A, Washing - Wiping).
READ NEXT:
K85
REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED
Remove:
the blanking covers (1),
the nuts (2).
Unclip the tailgate spoiler at (3).
Disconnect:
the high level brake light connecto
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the scuttle panel grille (see 56A, Exterior
equipment, Scuttle panel grille: Removal - Refitting, 56A-1).
Remove the trim under the scuttle pane
REMOVAL
I - REMOVAL PREPARATION OPERATION
Unclip the trim (1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Remove:
the sealing foam (2),
the bolts (3)
the door mirror.
Disconnect th
SEE MORE:
I - PREREQUISITES FOR WHEEL BALANCING
Wheel balancing is a measurement operation.
Several conditions must be met to achieve a reliable
result in a single operation.
The wheel balancer must be installed in accordance
with the manufacturer's instructions.
It is essential to calibrate the bala
Note:
The information contained in the following
describes the general repair procedure for all vehicles
having the same design for this part.
Before reading this general information, check that
there are no special notes associated with this vehicle.
These special notes will be specified if appli
© 2016-2025 Copyright Renault Clio Owners Club
