Renault Clio: Relay shaft bearing: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Transmission / Driveshafts / Relay shaft bearing: Removal - Refitting
M4R, and TL4
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment).
- Disconnect the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery).
- Remove the front right-hand driveshaft (see 29A, Driveshafts, Front right-hand driveshaft: Removal - Refitting, 29A-9).
II - REMOVAL OF PART CONCERNED
Removing the relay shaft bearing
- Remove the lock ring (7) from the bearing (8).
- Extract the bearing (8) using a press and an extractor.
- Take care not to scratch the contact surface of the lip seal on the relay shaft (9).
REFITTING
I - REFITTING PART CONCERNED
- Lubricate the contact surface of the shaft into which the bearing is inserted.
- Insert the new bearing.
- Fit the bearing to the end using a tube, so that it rests on the inner bearing race.
- Fit a new lock ring.
- Clean and grease the bearing hole into which the bearing will be inserted.
II - FINAL OPERATION.
- Refit the front right-hand driveshaft (see 29A, Driveshafts, Front right-hand driveshaft: Removal - Refitting, 29A-9).
- Connect the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery).
READ NEXT:
Front driveshaft gaiter, wheel side: Removal -
Refitting
M4R, and TL4
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the driveshaft on the side concerned (see
29A, Driveshafts, Front right-hand driveshaft:
Removal - Refitting, 29A-9) or (see 29A,
Dr
Front right-hand driveshaft gaiter, gearbox side: Removal - Refitting
DP0 or JH3 or JR5 or TL4
Deflector
Propeller shaft
Driveshaft yoke sleeve
Spider
RC gaiter
Tightening clip
Lock ring
Tightening ring
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the
Front left-hand driveshaft gaiter, gearbox side: Removal - Refitting
DP0 or JH3 or JR5 or TL4
Tightening clip
Tightening ring
Cup
Driveshaft yoke sleeve
Deflector
Propeller shaft
RC gaiter
Spider
Lock ring
Spring
REMOVAL
I - REMOVAL PREPARATION OPERATION
SEE MORE:
Reversing camera
Operation
Moving into reverse gear, the 1 camera
(located on the tailgate on five-seater
versions or near the number plate lights
on estate versions) provides a view of
the area behind the vehicle on the 2
touchscreen. Depending on the vehicle,
this may be accompanied by a
moving guide l
Rear parcel shelf side trim: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
C85
Remove the rear wing panel trim (see 71A, Body internal
trim, Rear panel lining: Removal - Refitting, 71A-32).
B85
Unclip the rear inner sill upper trim (see 71A, Body
internal trim, Rear inner sill upper trim: Removal
- Refitting, 71A-24).
B85
© 2016-2025 Copyright Renault Clio Owners Club
