Renault Clio: Rubber bush: Adjustment
Renault Clio III (2005-2013) Service Manual / Chassis / Rear Axle Components / Rubber bush: Adjustment
WARNING
Never use the rear axle as support for a lifting system.
ADJUSTMENT
- Position the vehicle on a two-post lift (see Vehicle: Towing and lifting).
- Release the parking brake.
- Remove the rear wheels (see 35A, Wheels and tyres, Wheel: Removal - Refitting, 35A-1).
- Unclip the speed sensor harness at (1).
- Loosen the rubber bush nuts (2).
- Remove the springs (see 33A, Rear axle components, Rear suspension spring: Removal - Refitting, 33A-27).
- Place the tool component jack in contact with a shim under the rear axle near the shock absorber at (3).
- Adjust the component jack in order to obtain a distance (X1) of 150 mm between the lower mounting of the shock absorber and the side member.
- Torque tighten the rubber bush bolt (105 N.m).
- Do the same for the other side.
- Refit the springs (see 33A, Rear axle components, Rear suspension spring: Removal - Refitting, 33A-27).
- Clip on the speed sensor harness.
- Refit the rear wheels (see 35A, Wheels and tyres, Wheel: Removal - Refitting, 35A-1).
READ NEXT:
Rear brake pads: Removal - Refitting
16" ALUMINIUM WHEELS or 17" ALUMINIUM WHEELS or 16" STEEL WHEELS, and
ELECTRONIC STABILITY
PROGRAM
When replacing brake pads, be sure to replace the
pads on the opposite side.
WARNING
To avoid damag
Rear brake hose: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
WARNING
Prepare for brake fluid outflow, to p
Rear brake calliper: Repair
WARNING
Prepare for the flow of fluid, and protect the surrounding
components.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (
SEE MORE:
Passenger's front side door wiring: Removal -
Refitting
IMPORTANT
Consult the safety and cleanliness advice and operation
recommendations before carrying out any
repair (see 88A, Wiring harness, Wiring: Precautions
for the repair, 88A-5).
REMOVAL
I - REMOVAL PREPARATION OPERATION
Raise the window fully.
Switch off the ignition.
Disconnect the battery
Wheel speed sensor: Removal - Refitting
EQUIPMENT LEVEL EAC or EQUIPMENT LEVEL SPORT
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see 02A, Lifting
Equipment, Vehicle: Towing and lifting).
Disconnect the battery (see 80A, Battery, Battery:
Removal - Refitting).
Remove:
the front wheels (see 35
© 2016-2025 Copyright Renault Clio Owners Club
