Renault Clio: Hill start assistance
Renault Clio IV (2014-2019) Owners Manual / Driving / Driver correction devices and aids / Hill start assistance
This function assists the driver when starting on hills. It prevents the vehicle from rolling backwards, depending on the slope, by automatically applying the brakes when the driver lifts his/her foot off the brake pedal to depress the accelerator pedal.
System operation
It only operates when the gear lever is in a position other than neutral (other than N or P for automatic transmissions) and the vehicle is completely stationary (brake pedal depressed) The system holds the vehicle for approximately 2 seconds. The brakes are then gradually released (the vehicle will move according to the slope).
| The hill start assistance
system cannot completely
prevent the vehicle from
rolling backwards in all situations
(extremely steep gradients,
etc.). In all cases, the driver may depress the brake pedal to prevent the vehicle from rolling forwards or backwards. The hill start assistance function should not be used for prolonged stops: use the brake pedal. This function is not designed to immobilise the vehicle permanently. If necessary, use the brake pedal to stop the vehicle. The driver must remain particularly vigilant when driving on slippery or low-grip surfaces and/or on hills. Risk of serious injury |
READ NEXT:
Speed limiter
The speed limiter function helps you
stay within the driving speed limit that
you choose, known as the limit speed.
Controls
Main “On/Off” switch.
Limit speed activation, storage
Cruise control
The cruise control function helps you to
maintain your driving speed at a speed
that you choose, called the cruising
speed.
This cruising speed may be set at any
speed above 20 mph (30 km/h
Parking sensor
Operating principle
Ultrasonic detectors, installed in the
rear bumper (depending on the vehicle),
measure the distance between the
vehicle and an obstacle whilst reversing.
This measurement is
SEE MORE:
Specialised bodywork tools: Use
USING THE DASHBOARD CROSS MEMBER
REMOVAL TOOL Car. 1765
Use this tool as indicated in the dashboard removal
procedure.
Fit the tool Car. 1765 as far as the stop (10).
Screw the rod (11) onto the body (10) as far as the
stop.
Firmly lock tool body in the same way as a lock nut
against th
Sunroof opening control: Removal - Refitting
PANORAMIC SUNROOF
REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED
Unclip the roof opening control using a flat-blade screwdriver (1).
Disconnect the connectors.
REFITTING
REFITTING OPERATION FOR PART CONCERNED
Connect the connectors.
Clip the sunroof opening control.
Sunroof operating mecha
