Renault Clio: Scuttle panel grille: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove the wiper arms (see Windscreen wiper
arm: Removal - Refitting) (MR 392, Mechanical
systems, 85A, Washing - Wiping).

II - OPERATION FOR REMOVAL OF PART
CONCERNED


- Remove the scuttle panel grille (3) and (4).
REFITTING
I - REFITTING PREPARATION OPERATION
Note:
Check that the windscreen and the scuttle panel
grille are clean before refitting.
II - REFITTING OPERATION FOR PART
CONCERNED

- Refit:
- the scuttle panel grille,
- the clips (5).
III - FINAL OPERATION.

- Refit:
- the seal (6),
- the wiper arms (see Windscreen wiper arm: Removal
- Refitting) (MR 392, Mechanical systems,
85A, Washing - Wiping).
READ NEXT:
K85
REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED
Remove:
the blanking covers (1),
the nuts (2).
Unclip the tailgate spoiler at (3).
Disconnect:
the high level brake light connecto
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the scuttle panel grille (see 56A, Exterior
equipment, Scuttle panel grille: Removal - Refitting, 56A-1).
Remove the trim under the scuttle pane
REMOVAL
I - REMOVAL PREPARATION OPERATION
Unclip the trim (1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Remove:
the sealing foam (2),
the bolts (3)
the door mirror.
Disconnect th
SEE MORE:
D4F
I - VALVE CLEARANCE ADJUSTMENT
PREPARATION OPERATION
Fit the vehicle on a two-post lift (see Vehicle: Towing and lifting).
Remove:
the front right-hand wheel (see Wheel: Removal - Refitting),
the front right-hand wheel arch liner (see MR 393
Bodywork, 55A, Exterior protection, Front
The thrust bearing is connected to the clutch slave cylinder.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Drain the brake reservoir using a syringe to remove
the clutch thrust bearing and control.
Remove the gearbox (see 21A, Manual gearbox,
Manual gearbox: Removal - Refitting, 21A- 12).
II - R
© 2016-2025 Copyright Renault Clio Owners Club
