Renault Clio: Battery for remote door locking control: Removal - Refitting
REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED
VEHICLE WITH KEY


- Open the key with a coin (2).
VEHICLE WITH CARD

- Remove the mechanical insert (3).
REFITTING
I - REFITTING PREPARATION OPERATION
WARNING
To ensure that the remote control operates correctly,
take care not to damage the battery contacts.
Only handle the new battery with dry, grease-free
hands or wearing clean gloves to avoid any risk
of dirt and oxidation on the battery.
II - REFITTING OPERATION FOR PART
CONCERNED
VEHICLE WITH KEY

- Replace the battery (4) using a flat-blade screwdriver.
VEHICLE WITH CARD

III - FINAL OPERATION.
VEHICLE WITH KEY
- Close the key.
- Tighten the bolt (1).
VEHICLE WITH CARD
- Refit the mechanical insert (6).
READ NEXT:
VEHICLE WITH CARD
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the centre console (see Centre console:
Removal - Refitting) (MR 393, 57A, Interior equipment).
Unclip the trim at (1) and (2
Clock: Before/after repair procedure
SETTING THE CLOCK
WITHOUT NAVIGATION AID, and RADIO NO. 01
or RADIO NO. 02 or RADIO NO. 03 or RADIO NO.
04 or RADIO NO. 05 or RADIO NO. 06 or RADIO
NO. 07 or RADIO
SEE MORE:
JH3 or JR5
Note:
Each time an operation is carried out on the
hydraulic clutch system, bleed the circuit:
between the reservoir and the bleed hole,
between the bleed hole and the clutch release
bearing.
REMOVAL
I - REMOVAL PREPARATION OPERATION
K4J or K4M
Remove the resonator.
Remov
D4F or F4R or K4J or K4M or M4R
WARNING
The breather must not be blocked during normal
engine operation.
The tank is vented through the fuel vapour absorber.
Fuel vapour is trapped by the active carbon contained
in the absorber as it passes through.
Fuel vapour trapped in the absorber is eliminate
© 2016-2025 Copyright Renault Clio Owners Club
