Renault Clio: Engine wiring: Connector access
Renault Clio III (2005-2013) Service Manual / Electrical Equipment / Wiring Harness / Engine wiring: Connector access
I - LOCATION OF CONNECTORS
- R 67 connector (Engine wiring harness/front left-hand wiring connection).
- Depending on the engine, connection R 67 is composed of three or four connectors.
K4J or K4M
- R 37 connector (Engine wiring harness/injection connection).
D4F
- R 37 connector (Engine wiring harness/injection connection).
- R 235 connector (Automatic transmission wiring/ dashboard wiring connection).
F4R
- R 37 connector (Engine wiring harness/injection connection).
M4R
- R 20 connector (Engine wiring harness/injection connection).
- R 24 connector (Engine wiring harness/injection connection).
II - ACCESS TO CONNECTORS
IMPORTANT
Consult the safety and cleanliness advice and operation recommendations before carrying out any repair (see 88A, Wiring harness, Wiring: Precautions for the repair, 88A-5).
WARNING
To prevent damaging the connectors, consult the disconnection procedure (see Connector: Disconnection and reconnection) (Technical Note 6015A, 88A, Wiring).
- Switch off the ignition.
- Disconnect the battery (see 80A, Battery, Battery: Removal - Refitting, 80A-1)
1 - Access to the R 67 connectors
- Remove:
- the bolts (1),
- the Protection and Switching Unit cover.
- Disconnect the R 67 connectors.
2 - Access to the R 37 connector
K4J or K4M
- Remove the front engine cover.
- Disconnect the R 37 connector.
D4F
- Remove the air filter box (see Air filter unit: Removal - Refitting) (MR 392, 12A, Fuel mixture).
- Disconnect the R 37 connector.
F4R
- Disconnect the R 37 connector.
3 - Access to the R 235 connector
D4F
- Remove:
- the battery (see 80A, Battery, Battery: Removal - Refitting, 80A-1),
- the battery tray bracket (see 80A, Battery, Battery tray: Removal - Refitting, 80A-5).
- Disconnect the R 235 connector.
4 - Access to the R 20 and R 24 connectors
M4R
- Remove the front engine cover.
- Disconnect the R 20 and R 24 connectors.
READ NEXT:
K4J or K4M
IMPORTANT
Consult the safety and cleanliness advice and operation
recommendations before carrying out any
repair (see 88A, Wiring harness, Wiring: Precautions
for the repair, 88A-5).
WARNING
To preve
K9K
IMPORTANT
Consult the safety and cleanliness advice and operation
recommendations before carrying out any
repair (see 88A, Wiring harness, Wiring: Precautions
for the repair, 88A-5).
WARNING
To preve
SEE MORE:
Engine coolant
With the engine switched off and on
level ground, the level when cold must
be between the MINI and MAXI marks
on reservoir 1.
Top this level up when cold before it
reaches the MINI mark.
When working in the engine
compartment, ensure that
the windscreen wiper stalk
is in
Driving advice, Eco-driving
Behaviour
Drive carefully for the first few miles
until the engine reaches its normal
operating temperature, rather than
let it warm up while the vehicle is stationary.
Speed is expensive.
Sporty driving uses a lot of fuel: drive
with a light right foot.
Do not overrev the engi
© 2016-2025 Copyright Renault Clio Owners Club
