Renault Clio: Gear selection sensor: Removal - Refitting

Renault Clio III (2005-2013) Service Manual / Transmission / Sequential Gearbox / Gear selection sensor: Removal - Refitting

K9K, and JA5

REMOVAL

I - REMOVAL PREPARATION OPERATION

WARNING

To remove the gear selection sensor it is essential that you shift to first gear before removal.

• Remove:
  • the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery),
  • the battery tray (see Battery tray: Removal - Refitting) (MR 392, 80A, Battery),
  • the air filter unit (see Air filter unit: Removal - Refitting) (MR 392, 12A, Fuel mixture).

II - OPERATION FOR REMOVAL OF PART CONCERNED

• Disconnect the gear selection sensor connector (1).
• Remove:
  • the gear selection sensor bolts,
  • the gear selection sensor (1).

REFITTING

I - REFITTING PREPARATIONS OPERATION

• Check that the gear selection sensor is able to rotate freely.

II - REFITTING OPERATION FOR PART CONCERNED

• Refit:
  • the gear selection sensor,
  • the gear selection sensor bolts.
• Torque tighten the gear selection sensor bolts (4 Nm).
• Connect the gear selection sensor connector.

III - FINAL OPERATION.

• Refit:
  • the air filter unit (see Air filter unit: Removal - Refitting) (MR 392, 12A, Fuel mixture),
  • the battery tray (see Battery tray: Removal - Refitting) (MR 392, 80A, Battery),
  • the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery),
• Carry out the necessary programming (see Fault finding - Replacement of components (MR 394, 21B, Sequential gearbox).

D4F, and JA3

REMOVAL

I - REMOVAL PREPARATION OPERATION

WARNING

To remove the gear selection sensor it is essential that you shift to first gear before removal.

• Remove:
  • the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery),
  • the battery tray (see Battery tray: Removal - Refitting) (MR 392, 80A, Battery).

II - OPERATION FOR REMOVAL OF PART CONCERNED

• Disconnect the gear selection sensor connector (1).
• Remove:
  • the gear selection sensor bolts,
  • the gear selection sensor (1).

REFITTING

I - REFITTING PREPARATIONS OPERATION

• Check that the gear selection sensor is able to rotate freely.

II - REFITTING OPERATION FOR PART CONCERNED

• Refit:
  • the gear selection sensor,
  • the gear selection sensor bolts.
• Torque tighten the gear selection sensor bolts (4 Nm).
• Connect the gear selection sensor connector.

III - FINAL OPERATION.

• Refit:
  • the battery tray (see Battery tray: Removal - Refitting) (MR 392, 80A, Battery),
  • the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery).
• Carry out the necessary programming (see Fault finding - Replacement of components (MR 394, 21B, Sequential gearbox).

READ NEXT: