Renault Clio: Accelerator pedal: Removal - Refitting

VERSION WITHOUT ADAPTATION SUPPLEMENT

REMOVAL

I - REMOVAL PREPARATION OPERATION

• Remove:
  • the retaining clips on the driver side dashboard lower trim,
  • the driver side dashboard lower trim.

II - OPERATION FOR REMOVAL OF PART CONCERNED

• Disconnect the accelerator pedal potentiometer connector (1).
• Remove:
  • the accelerator pedal mounting nuts (2),
  • the accelerator pedal.

REFITTING

I - REFITTING OPERATION FOR PART CONCERNED

• Refit:
  • the accelerator pedal,
  • the accelerator pedal mounting nuts,
• Connect the accelerator pedal potentiometer connector.
• Torque tighten the accelerator pedal mounting nuts (8 N.m).

II - FINAL OPERATION

• Refit:
  • the driver's side dashboard lower trim,
  • the retaining clips on the driver side dashboard lower trim,

SCHOOL VEHICLE

REMOVAL

I - REMOVAL PREPARATION OPERATION

• Disconnect the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery).

II - OPERATION FOR REMOVAL OF PART CONCERNED

1 - student side

• Disconnect the accelerator pedal potentiometer connector (1).
• Remove:
  • the circlip (2) from the accelerator pedal to the link bar connection control lever,
  • the accelerator pedal bolts (3),
  • the accelerator pedal.

2 - Instructor side

• Remove:
  • the circlip (4) from the accelerator pedal to the link bar connection control lever,
  • the accelerator pedal nut (5),
  • the accelerator pedal shaft,
  • the accelerator pedal.

REFITTING

I - REFITTING PREPARATIONS OPERATION

• Always replace the connecting circlips whenever they have been removed.

II - REFITTING OPERATION FOR PART CONCERNED

1 - student side

• Refit:
  • the accelerator pedal,
  • the accelerator pedal bolts (3),
  • the circlip (2) from the accelerator pedal to the link bar connection control lever.
• Torque tighten the accelerator pedal bolts, driver's side (8 Nm).
• Connect the accelerator pedal potentiometer connector (1).

2 - instructor side

• Refit:
  • the accelerator pedal,
  • the accelerator pedal shaft,
  • the accelerator pedal nut (5),
  • the circlip (4) from the accelerator pedal to the link bar connection control lever.
• Torque tighten the accelerator pedal shaft, instructor's side (16 Nm).

III - FINAL OPERATION.

• Connect the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery).

Emergency brake assist: Function

1. Without emergency brake assist
2. With emergency brake assist

Emergency brake assist is a system which supplements ABS.

Emergency brake assist enables the system to recognise the situation and act immediately to provide the best possible stopping distance.

Emergency braking is calculated according to how quickly the brake pedal is depressed; in this situation, braking assistance immediately reaches its maximum level of output.

The system works conditionally for current braking systems.

The emergency brake assist is a mechanical system built into the brake servo and completely independent of any electronic component.

The brake servo is fitted with a magnet which reacts by locking the control unit when the pedal is depressed sharply.

READ NEXT: