Renault Clio manuals

Renault Clio: In case of puncture

Renault Clio IV (2014-2019) Owners Manual / Practical advice / Puncture, emergency spare wheel / In case of puncture

Depending on the vehicle, a tyre inflation kit or emergency spare wheel is provided (refer to the following pages).

If the emergency spare wheel has been stored for several years, have it checked by your Dealer to ensure that it is safe to use.

Vehicle fitted with an emergency spare wheel that differs from the other wheels:

  • Never fit more than one emergency spare wheel to the same vehicle.
  • As the punctured wheel is wider than the emergency spare wheel, the vehicle’s ground clearance is reduced.
  • Replace the emergency spare wheel as soon as possible with a wheel identical to the original one.
  • When this is fitted to the vehicle, which must only be a temporary measure, the driving speed must not exceed the speed indicated on the label on the wheel.
  • Fitting an emergency spare wheel may alter the way the vehicle usually runs.

    Avoid sudden acceleration or deceleration and reduce your speed when cornering.

  • If you need to use snow chains, fit the emergency spare wheel to the rear axle and check the tyre pressure.

READ NEXT:

 Emergency spare wheel

Open the tailgate; lift the carpet; lift the cover 1 and remove it; remove the tool kit by lifting it by its handles; The label 2 reminds you of how to operate the emergenc

 To refit a wheel

A wheel size larger than 15” cannot be installed under the vehicle. To carry out this operation, the cable must be unwound. If the cable has been wound back up on its ow

 To lock the system

Press nut 3, screwing it on fully until it locks in place. Several turns will be necessary. This operation is essential to ensure that the wheel is secure; return handle 4 to its orig

SEE MORE:

 Heater plugs: Removal - Refitting

K9K, and 764 or 772 REMOVAL I - REMOVAL PREPARATION OPERATION Remove the air filter box inlet air pipe (1). Remove the turbocharger outlet air pipe retaining pins (2). Remove: the turbocharger outlet air pipe bolt (3), the turbocharger outlet air pipe Undo the clip (4) from the int

 Speed sensor: Removal - Refitting

DP0 Do not drain or remove the automatic gearbox in order to remove the speed sensor. The output speed sensor has been deleted and replaced with wheel speed sensors. REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A,

© 2016-2025 Copyright Renault Clio Owners Club