Renault Clio manuals

Renault Clio: In case of puncture

Renault Clio IV (2014-2019) Owners Manual / Practical advice / Puncture, emergency spare wheel / In case of puncture

Depending on the vehicle, a tyre inflation kit or emergency spare wheel is provided (refer to the following pages).

If the emergency spare wheel has been stored for several years, have it checked by your Dealer to ensure that it is safe to use.

Vehicle fitted with an emergency spare wheel that differs from the other wheels:

  • Never fit more than one emergency spare wheel to the same vehicle.
  • As the punctured wheel is wider than the emergency spare wheel, the vehicle’s ground clearance is reduced.
  • Replace the emergency spare wheel as soon as possible with a wheel identical to the original one.
  • When this is fitted to the vehicle, which must only be a temporary measure, the driving speed must not exceed the speed indicated on the label on the wheel.
  • Fitting an emergency spare wheel may alter the way the vehicle usually runs.

    Avoid sudden acceleration or deceleration and reduce your speed when cornering.

  • If you need to use snow chains, fit the emergency spare wheel to the rear axle and check the tyre pressure.

READ NEXT:

 Emergency spare wheel

Open the tailgate; lift the carpet; lift the cover 1 and remove it; remove the tool kit by lifting it by its handles; The label 2 reminds you of how to operate the emergenc

 To refit a wheel

A wheel size larger than 15” cannot be installed under the vehicle. To carry out this operation, the cable must be unwound. If the cable has been wound back up on its ow

 To lock the system

Press nut 3, screwing it on fully until it locks in place. Several turns will be necessary. This operation is essential to ensure that the wheel is secure; return handle 4 to its orig

SEE MORE:

 Exhaust gas recirculation: List and location of components

K9K K9K, and 764 or 766 or 768 or 772 First fitting of the exhaust gas cooler recirculation assembly (1) Exhaust gas recirculation solenoid valve (2) Exhaust gas cooler (3) Exhaust gas inlet pipe (4) Metal air inlet tube (5) Cooler support on the flywheel end (6) Cooler support on the timing side S

 Headlight bulb: Removal - Refitting

DOCUMENTATION PHASE 1 REMOVAL DISCHARGE LAMPS IMPORTANT To prevent eye injuries: do not look at a xenon bulb when lit (voltage when lit 20000 V), do not light a bulb which has not been fitted into its headlight. IMPORTANT To prevent burns, wait until the " computers - power unit " assemblies a

© 2016-2025 Copyright Renault Clio Owners Club