Renault Clio: Crankshaft position sensor: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Engine And Peripherals / Diesel Injection / Crankshaft position sensor: Removal - Refitting
K9K, and 764 or 766 or 768
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Position the vehicle on a two-post lift (see Vehicle: Towing and lifting).
- Disconnect the battery (see Battery: Removal - Refitting).
- Remove the engine undertray.
II - OPERATION FOR REMOVAL OF PART CONCERNED
- Disconnect the connector (1) from the engine speed and position sensor.
- Remove the engine speed and position sensor (2).
REFITTING
I - REFITTING OPERATION FOR PART CONCERNED
- Refit the engine speed and position sensor.
- Connect the engine speed and position sensor connector.
II - FINAL OPERATION
- Refit the engine undertray.
- Connect the battery (see Battery: Removal - Refitting).
K9K, and 750 or 752
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove the air filter unit air inlet pipe.
II - OPERATION FOR REMOVAL OF PART CONCERNED
- Disconnect the connector (1) from the engine speed and position sensor.
- Remove:
- the engine speed and position sensor bolts (2),
- the engine speed and position sensor.
REFITTING
I - REFITTING OPERATION FOR PART CONCERNED
- Refit:
- the speed and position sensor,
- the engine speed and position sensor bolts.
- Connect the engine speed and position sensor connector.
II - FINAL OPERATION
- Refit the air filter unit air inlet pipe.
READ NEXT:
Pre-postheating unit: Removal - Refitting
K9K
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the battery (see Battery: Removal - Refitting),
the battery tray (see Battery tray: Removal - Refitting)
(MR 392, 80A, Battery).
II
Heater plugs: Removal - Refitting
K9K, and 764 or 772
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the air filter box inlet air pipe (1).
Remove the turbocharger outlet air pipe retaining pins (2).
Remove:
the turbochar
SEE MORE:
Parking sensor
Operating principle
Ultrasonic detectors, installed in the
rear bumper (depending on the vehicle),
measure the distance between the
vehicle and an obstacle whilst reversing.
This measurement is indicated by
beeps which become more frequent the
closer you come to the obstacle, until
they be
Crankshaft accessories
pulley: Removal - Refitting
D4F, and 740 or 742 or 764
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Remove:
the front right-hand wheel (see Wheel: Removal -
Refitting) (MR 392, 35A, Wheels and tyres),
the front r
© 2016-2025 Copyright Renault Clio Owners Club
