Renault Clio: Engine cooling: Parts and consumables for the repair
Renault Clio III (2005-2013) Service Manual / Engine And Peripherals / Cooling / Engine cooling: Parts and consumables for the repair
INGREDIENT
Coolant GLACEOL RX (TYPE D)
Note: Ready-to-use coolant or antifreeze must be diluted with distilled water in accordance with the guidelines marked on the container.
Engine cooling: Precautions for the repair
IMPORTANT
The circuits are designed to be pressurized, so be careful at high temperatures (risk of serious burns).
Never remove the cap from the expansion bottle while the engine is hot.
Take care when carrying out a repair under the bonnet, as the radiator fan(s) may start to operate without warning.
Do not open the bleed valve(s) while the engine is running.
Only use recommended coolants: GLACEOL RX (TYPE D).
WARNING
- The coolant helps to keep the engine running properly (heat exchange).
- The system does not operate using pure water.
WARNING
Take care not to damage the cooling unit fins (radiator, condenser, etc.) during handling. When carrying out a repair that requires a complete circuit drain, it is essential to flush the circuit with clean water, blow compressed air through the circuit to eliminate water, fill and drain the circuit and then " measure the effective protection " . The parameters to be observed are:
- protection down to - 25
READ NEXT:
Engine cooling system: Check
IMPORTANT
When working in the engine compartment, take
care as the radiator fan(s) may start up unexpectedly
(risk of being cut).
To avoid any risk of serious burns when the engine
is hot:
do not
Engine cooling system: Operating diagram
D4F
D4F, and 740 or 742 or 764
Engine
Cooling radiator
heater matrix
Expansion bottle
Water pump
Thermostat
Bleed screws
5 mm restriction
10 mm restriction
Note:
The rating of the expansio
Cooling system: Draining - Refilling
IMPORTANT
The circuits are designed to be pressurised, so be
careful at high temperatures (risk of serious burns).
Do not remove the cap from the expansion bottle
while the engine is hot.
Take care
SEE MORE:
Catalytic converter: Removal - Refitting
K4J or K4M
IMPORTANT
Catalytic converters contain ceramic fibres: these
are contained within a closed unit, and cannot disperse.
Cutting or drilling catalytic converters is prohibited.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lif
Fuel tank: Removal - Refitting
D4F or F4R or K4J or K4M or K9K or M4R - S85
IMPORTANT
During this operation, be sure to:
be careful of fuel splashes when disconnecting the
union.
IMPORTANT
Wear goggles with side protectors for this operation.
IMPORTANT
Wear latex gloves during the operation.
WARNING
To prevent impurities fro
