Renault Clio: Evaporator: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Air Conditioning / Air Conditioning / Evaporator: Removal - Refitting
AIR CONDITIONING or CLIMATE CONTROL
Note: The evaporator is supplied already assembled in the distribution unit. (1)
REMOVAL
OPERATION FOR REMOVAL OF PART CONCERNED
- Remove the distribution unit (see 61A, Heating, Distribution unit: Removal - Refitting, 61A- 50).
REFITTING
REFITTING OPERATION FOR PART CONCERNED
- Refit the distribution unit (see 61A, Heating, Distribution unit: Removal - Refitting, 61A-50).
Evaporator: Cleaning
AIR CONDITIONING or CLIMATE CONTROL
WARNING
Do not spray the cleaner via the air inlet, as this could damage the fan assembly.
REMOVAL
LEFT-HAND DRIVE
- Remove the cabin filter (see 61A, Heating, Cabin filter: Removal - Refitting, 61A-17).
- Apply the air conditioning cleaner using an extension piece.
- Spray the entire aerosol.
- Leave the product to work for 15 minutes.
- Run the fan assembly very slowly for 5 minutes.
RIGHT-HAND DRIVE
- Remove the cabin filter (see 61A, Heating, Cabin filter: Removal - Refitting, 61A-17).
- Apply the air conditioning cleaner.
- Spray the entire aerosol.
- Leave the product to work for 15 minutes.
- Run the fan assembly slowly for 5 minutes.
REFITTING
- Refit the cabin filter.
- Clip on the cabin filter.
READ NEXT:
Expansion valve - intermediate pipe connecting pipe at the expansion valve outlet: Removal -
Refitting
F4R or K9K or M4R, and AIR CONDITIONING or CLIMATE CONTROL
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions and operation
recommendations before car
Dehydrator reservoir - expansion valve connecting pipe: Removal - Refitting
AIR CONDITIONING or CLIMATE CONTROL
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions and operation
recommendations before carrying out any
repair:
Expansion valve - compressor connecting pipe: Removal - Refitting
D4F or K4J or K4M, and AIR CONDITIONING or CLIMATE CONTROL
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions and operation
recommendations before car
SEE MORE:
Headlight: Adjustment
DOCUMENTATION PHASE 1
ADJUSTMENT
I - PREPARATION OPERATION FOR CHECK
Place the vehicle in a working area equipped with a
two-post lift.
Note:
Check that the lift is on flat, horizontal ground.
Do not apply the parking brake.
Check and inflate the tyres to the recommended
pressure (see Tyre
Sequential gearbox: Precautions for the repair
D4F or K9K, and JA3 or JA5
I - SEQUENTIAL GEARBOX
WARNING
If any operation is carried out on the electro-hydraulic
unit, it is essential to clean the unit using a cleaning
product and compressed air.
Never leave the circuit open and never use a high
pressure cleaner.
II - SEQUENTIAL GEARBOX COMPUT
© 2016-2025 Copyright Renault Clio Owners Club
