Renault Clio: Rear suspension spring: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Chassis / Rear Axle Components / Rear suspension spring: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Position the vehicle on a two-post lift (see Vehicle: Towing and lifting).
- Remove the rear wheels (see 35A, Wheels and tyres, Wheel: Removal - Refitting, 35A-1).
II - OPERATION FOR REMOVAL OF PART CONCERNED
- Unpick the wheel speed sensor wiring harnesses (1)
- Using a block, bring the component jack into contact under the rear axle, near the shock absorber.
- Mark the position where the springs are fitted.
- Remove the shock absorber lower mounting (2).
- Remove the component jack.
- Repeat these operations on the opposite side.
- Remove the springs by withdrawing the component jack.
- Leave the rear axle suspended.
REFITTING
I - REFITTING OPERATION FOR PART CONCERNED
- Using a block, bring the component jack into contact under the rear axle, near the shock absorber.
- Refit the springs in their housing.
- Compress the rear axle.
- Refit the lower shock absorber mounting bolts.
- Torque tighten the shock absorber lower mounting bolts (105 Nm).
- Mount the wheel speed sensor wiring.
II - FINAL OPERATION.
- Remove the component jack.
- Refit the rear wheels (see 35A, Wheels and tyres, Wheel: Removal - Refitting, 35A-1).
READ NEXT:
Rear drum bearing: Removal - Refitting
Using a dial gauge connected to the drum, check that
the end float is greater than 0.03 mm.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle: Towing and
Rear disc bearing: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Put the vehicle on a two-post lift (see Vehicle: Towing and lifting).
Remove:
the rear wheels (see 35A, Wheels and tyres,
Wheel: Removal - Refitting, 3
Rear stub axle carrier: Removal - Refitting
DISC BRAKE
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Remove:
the rear wheel in questi
SEE MORE:
Shock absorber: Removal - Refitting
WARNING
To prevent any damage, do not use the rear axle as
support for the lifting system.
WARNING
To prevent any suspension asymmetry, replace
both of the shock absorbers on the same axle.
WARNING
To prevent the components of the rear axle from
deteriorating (rubber bushes, brake hoses, etc.) do
n
Remote headlight beam adjustment actuator: Removal - Refitting
DOCUMENTATION PHASE 1
DISCHARGE LAMPS
IMPORTANT
To prevent burns, wait until the " computers -
power unit " assemblies are cold before removal.
IMPORTANT
To prevent eye injuries:
do not look at a xenon bulb when lit (voltage
when lit 20000 V),
do not light a bulb which has not been fitted into
© 2016-2025 Copyright Renault Clio Owners Club
