Renault Clio: Engagement sensor: Removal - Refitting

Renault Clio III (2005-2013) Service Manual / Transmission / Sequential Gearbox / Engagement sensor: Removal - Refitting

K9K, and JA5

REMOVAL

I - REMOVAL PREPARATION OPERATION

• Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment).
• Disconnect the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery).
• Remove the front left-hand wheel (see Wheel: Removal - Refitting) (MR 392, 35A, Wheels and tyres).

II - OPERATION FOR REMOVAL OF PART CONCERNED

• Disconnect the engagement sensor connector.
• Remove:
  • the engagement sensor bolts,
  • the engagement sensor (1).

REFITTING

I - REFITTING OPERATION FOR PART CONCERNED

• Refit:
  • the engagement sensor,
  • the engagement sensor bolts.
• Tighten to torque the engagement sensor bolts (4 Nm).
• Connect the engagement sensor connector.

II - FINAL OPERATION.

• Connect the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery).
• Refit the front left-hand wheel (see Wheel: Removal - Refitting) (MR 392, 35A, Wheels and tyres).
• Carry out the necessary programming (see Fault finding - Replacement of components) (MR 394, 21B, Sequential gearbox).

WARNING

After the accumulator has been fully filled (15 seconds after the ignition has been switched on): the oil is at the MIN mark.

D4F, and JA3

REMOVAL

I - REMOVAL PREPARATION OPERATION

• Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment).
• Disconnect the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery).
• Remove the front left-hand wheel (see Wheel: Removal - Refitting) (MR 392, 35A, Wheels and tyres).

II - OPERATION FOR REMOVAL OF PART CONCERNED

• Disconnect the engagement sensor connector.
• Remove:
  • the engagement sensor bolts,
  • the engagement sensor (1).

REFITTING

I - REFITTING OPERATION FOR PART CONCERNED

• Refit:
  • the engagement sensor,
  • the engagement sensor bolts.
• Tighten to torque the engagement sensor bolts (4 Nm).
• Connect the engagement sensor connector.

II - FINAL OPERATION.

• Connect the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery).
• Refit the front left-hand wheel (see Wheel: Removal - Refitting) (MR 392, 35A, Wheels and tyres).
• Carry out the necessary programming (see Fault finding - Replacement of components) (MR 394, 21B, Sequential gearbox).

WARNING

After the accumulator has been fully filled (15 seconds after the ignition has been switched on): the oil is at the MIN mark.

READ NEXT: