Renault Clio: Rear brake disc: Removal - Refitting

Renault Clio III (2005-2013) Service Manual / Chassis / Rear Axle Components / Rear brake disc: Removal - Refitting

DISC BRAKE

Brake discs cannot be reground. If there is excessive scoring or wear, they will need to be replaced (see 30A, General information, Brake: Specifications, 30A-9).

When replacing a brake disc, be sure to replace the disc on the opposite side.

Be sure to replace the brake pads if the brake discs are being replaced.

REMOVAL

I - REMOVAL PREPARATION OPERATION

• Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment).
• Remove:
  • the rear wheels (see 35A, Wheels and tyres, Wheel: Removal - Refitting, 35A-1),
  • the rear brake pads (see 33A, Rear axle components, Rear brake pads: Removal - Refitting, 33A-3),
  • the calliper mountings (see 33A, Rear axle components, Rear brake calliper mounting: Removal - Refitting, 33A-10).

II - OPERATION FOR REMOVAL OF PART CONCERNED

• Remove:
  • the hub covers (1)
  • the stub axle nuts (2),
  • the brake discs.

REFITTING

I - REFITTING PREPARATIONS OPERATION

• Clean the brake discs using a spray.
• Clean the stub axle.

II - REFITTING OPERATION FOR PART CONCERNED

• Refit:
  • the brake discs,
  • the stub axle nuts.
• Torque tighten the stub axle nuts (175 Nm).
• Refit the hub cover plug.

III - FINAL OPERATION.

• Refit:
  • the calliper mounting (see 33A, Rear axle components, Rear brake calliper mounting: Removal - Refitting, 33A-10),
  • the rear brake pads (see 33A, Rear axle components, Rear brake pads: Removal - Refitting, 33A-3),
  • the rear wheels (see 35A, Wheels and tyres, Wheel: Removal - Refitting, 35A-1).

Rear brake disc: Description

I - PREPARATION OPERATION FOR CHECK

Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (02A, Lifting equipment).

Remove the rear wheel concerned (see 35A, Wheels and tyres, Wheel: Removal - Refitting, 35A-1).

II - CHECKING OPERATION FOR PART CONCERNED

Note: Use a Palmer type tool to check the thickness of the disc.

Position the Palmer tool (1) to measure the disc thickness.

Measure the thickness of the disc at 4 points in order (90

READ NEXT: