Renault Clio: Brake fluid
The level should be read with the engine switched off and on level ground.
This should be checked frequently, and immediately if you notice even the slightest loss in braking efficiency.
| The engine may be hot
when carrying out operations
in close proximity. In
addition, the engine cooling
fan can come on at any moment. Risk of injury. |
Level 2
It is normal for the level to drop as the brake shoes become worn, but it must never drop lower than the “MINI" warning line.
If you wish to check the disc and drum wear yourself, you should obtain the document explaining the checking procedure from the manufacturer’s network or web site.
Topping up
After any operation on the hydraulic circuit, a specialist must replace the brake fluid.
Only use fluids approved by our Technical Department (and taken from a sealed container).
Replacement interval
Refer to the Maintenance Document for your vehicle.
| Consult your approved dealer at once if you notice an abnormal or repeated drop in any of the fluid levels. |
READ NEXT:
Windscreen washer reservoir
Topping up
With the engine switched off, open the
cap 3. Fill until you can see the fluid,
then replace the cap.
Liquid
Screen wash product (product with
antifreeze in winter).
Filters
The replacement of filter components
(air filter, cabin filter, diesel filter, etc.)
is scheduled in the maintenance operations
for your vehicle.
Replacement intervals for filter elements:
refe
Tyre pressure
Label A
Open the driver’s door to read it.
Tyre pressures should be checked
when the tyres are cold.
If the tyre pressures cannot be checked
when the tyres are cold, increase the
press
SEE MORE:
Passenger compartment temperature sensor: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Unclip the upper casing.
Unclip the lower casing (1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Disconnect the passenger compartment temperature sensor connector (2).
Remove:
the passenger compartment temperature sensor
bolts located insid
Sunroof sun visors: Removal - Refitting
PANORAMIC SUNROOF
IMPORTANT
Before working on or near a safety system component;
make sure that the airbag computer is
locked using the Diagnostic tool. When this
function is activated, all the triggering lines are
inhibited and the airbag warning light on the
instrument panel is continuously lit (
