Renault Clio: Engine oil level: topping up, filling
Topping up/filling

The vehicle must be parked on level
ground and the engine should be cold
(for instance, before the engine is started
up for the first time in the day).
| Before performing any
action in the engine compartment,
the ignition must
be switched off by pressing
the engine stop button (please see
the information on “Starting, stopping
the engine” in Section 2). |

- Unscrew cap 1;
- top up the level (as a guide, the capacity
between the minimum and
maximum reading on the dipstick 2
is between 1.5 and 2 litres, depending
on the engine);
- wait for approximately 10 minutes to
allow the oil to flow into the engine;
- check the level using the dipstick 2
(as described above).
Once the operation has been completed,
ensure that the dipstick is pushed
in as far as it will go and that the cap is
completely screwed in.

| In order to prevent splashback, it is
recommended that a funnel be used
when topping up/filling with oil. |
| Do not exceed the max level and
do not forget to refit cap 1 and dipstick
2. |
Oil change

Service interval: refer to the
Maintenance Service Booklet for your
vehicle.
Oil change capacity
Please refer to the maintenance document
for your vehicle, or contact an authorised
dealer.
Always check the engine oil level using
the dipstick, as explained previously (it
should never fall below the minimum
level, or be over the maximum level on
the dipstick).
READ NEXT:
Refer to the Maintenance Service
Booklet for your vehicle.
Filling: take care when
topping up the oil that
no oil drips onto engine
components - risk of fire.
Remember to refit th
With the engine switched off and on
level ground, the level when cold must
be between the MINI and MAXI marks
on reservoir 1.
Top this level up when cold before it
reaches the MINI mark.
SEE MORE:
D4F, and 740 or 742 or 764
Petrol vapour rebreathing solenoid
valve
Air inlet pressure sensor
Motorised throttle valve
Injection computer
(5) Fuel injection computer
(6) Motorised throttle valve
(7) Fuel vapour recirculation solenoid
valve
(8) Ignition coil
(9) Upstream oxygen sensor
(1
K9K, and 772
IMPORTANT
During this operation, be sure to:
beware of fuel splashes when disconnecting the
union,
protect sensitive areas from fuel outflow.
IMPORTANT
Wear gloves during this operation.
IMPORTANT
Wear goggles with side protectors for this operation.
REMOVAL
I - REMOVAL PREPARATIO
© 2016-2025 Copyright Renault Clio Owners Club
