Renault Clio: Centre front panel: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Mechanisms And Accessories / Interior Equipment / Centre front panel: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove:
- the centre console (see 57A, Interior equipment, Centre console: Removal - Refitting, 57A- 14),
- the radio and/or the navigation system (see Radio: Removal - Refitting) (MR 392, 86A, Radio) or (see Radio navigation: Removal - Refitting) (MR 392, 83C, On-Board Telematics System).
- Unclip the lower trim (1) and (2).
II - OPERATION FOR REMOVAL OF PART CONCERNED
- Unclip the centre front panel (3) and (4).
- Disconnect the connectors.
REFITTING
I - REFITTING OPERATION FOR PART CONCERNED
- Connect the connectors.
- Clip in the centre front panel.
II - FINAL OPERATION.
- Refit:
- the lower trim,
- the radio and/or the navigation system (see Radio: Removal - Refitting) (MR 392, 86A, Radio) or (see Radio navigation: Removal - Refitting) (MR 392, 83C, On-Board Telematics System),
- the centre console (see 57A, Interior equipment, Centre console: Removal - Refitting, 57A- 14).
READ NEXT:
Interior rear-view mirror: Removal - Refitting
REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED
Unclip:
the upper cover,
the lower cover.
Note:
When removing the rear view mirror, be careful
not to damage the rain sensor nearby.
Disc
Dashboard cover gaiter: Removal - Refitting
IMPORTANT
Before carrying out any work on or near a safety
system component, lock the airbag computer
using the Diagnostic tool. When this function is
activated, all the trigger lines are disabled an
Safety Accessories
Front seat belt: Removal - Refitting
IMPORTANT
To avoid any risk of triggering when working on or
near a pyrotechnic component (airbags or pretensioners),
lock the airbag computer using the diagnosti
SEE MORE:
Headlight bulb: Removal - Refitting
DOCUMENTATION PHASE 1
REMOVAL
DISCHARGE LAMPS
IMPORTANT
To prevent eye injuries:
do not look at a xenon bulb when lit (voltage
when lit 20000 V),
do not light a bulb which has not been fitted into
its headlight.
IMPORTANT
To prevent burns, wait until the " computers -
power unit " assemblies a
Headlight beam adjustment front sensor: Removal - Refitting
DISCHARGE LAMPS
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a lift (see Vehicle: Towing
and lifting) (MR 392, 02A, Lifting equipment).
Remove:
the front wheels (see Wheel: Removal - Refitting)
(MR 392, 35A, Wheels and tyres),
the front axle subframe (see Front axle s
© 2016-2025 Copyright Renault Clio Owners Club
