Renault Clio: Charge circuit: Specifications

Renault Clio III (2005-2013) Service Manual / Engine And Peripherals / Starting - Charging / Charge circuit: Specifications

D4F or F4R or K4J or K4M or K9K or M4R

ALTERNATOR SPECIFICATIONS

Renault Clio. Charge circuit: Specifications

Charge circuit: Function

D4F or F4R or K4J or K4M or K9K or M4R

OPERATION

These vehicles are fitted with a built-in regulator and an instrument panel warning light which operates as follows:

when the ignition is switched on, the warning light comes on,
the warning light goes out when the vehicle is started,
if the warning light comes on while the engine is running, it indicates a battery charge fault.

Charge circuit: Check

D4F or F4R or K4J or K4M or K9K or M4R

Check the current after 30 minutes of heating at a voltage of 13.5 V.

Renault Clio. Charge circuit: Check

SEE MORE:

Water chamber: Removal - Refitting

D4F, and 740 or 742 or 784 REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Disconnect the battery (see ) (MR 392, 80A, Battery). D4F, and 740 or 742 Remove the air filter unit (see 12A, Fuel

Roof sun blind

Fixed sunroof blind Opening: push handle 1 upwards, then guide it until it opens fully; Closing: pull the handle 1 until it clicks into the catch. If the blind becomes skewed when opening or closing, close fully and then fully open the blind. Front sun visor Lower sun visor

Renault Clio: Charge circuit: Specifications

READ NEXT:

Alternator: Removal - Refitting

Starter: Removal - Refitting

Ignition

SEE MORE:

Water chamber: Removal - Refitting

Roof sun blind