Renault Clio: Drive plate: Removal - Refitting

K4M, and DP0

Renault Clio. Drive plate: Removal - Refitting

REMOVAL

I - REMOVAL PREPARATION OPERATION

II - OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Drive plate: Removal - Refitting

REFITTING

I - REFITTING PREPARATIONS OPERATION

II - REFITTING OPERATION FOR PART CONCERNED

READ NEXT:

 Top And Front Of Engine

 Pressure at end of compression: Check

K9K Remove the heater plugs (see 13C, Preheating, Heater plugs: Removal - Refitting, 13C-2). Disconnect: the pressure regulation solenoid valve connector (1), the flow control solenoid val

 Accessories belt: Removal - Refitting

K4J, and STANDARD HEATING - K4M, and STANDARD HEATING REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (02A, Lifting equipment).

SEE MORE:

 Brake pedal switch: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Remove: the retaining clips on the driver side dashboard lower trim, the driver side dashboard lower trim. II - OPERATION FOR REMOVAL OF PART CONCERNED WARNING Handle the brake light switch (2) with care. Actuate piston (4), only, to adjust t

 Compressor - condenser connecting pipe: Removal - Refitting

AIR CONDITIONING or CLIMATE CONTROL IMPORTANT To avoid all risk of damage to the systems, apply the safety and cleanliness instructions and operation recommendations before carrying out any repair: (see 62A, Air conditioning, Air conditioning: Precautions for the repair, 62A-1), (see Vehicle: P

© 2016-2025 Copyright Renault Clio Owners Club