Renault Clio: Drive plate: Removal - Refitting

K4M, and DP0

Renault Clio. Drive plate: Removal - Refitting

REMOVAL

I - REMOVAL PREPARATION OPERATION

II - OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Drive plate: Removal - Refitting

REFITTING

I - REFITTING PREPARATIONS OPERATION

II - REFITTING OPERATION FOR PART CONCERNED

READ NEXT:

 Multifunction switch: Removal - Refitting

DP0 REMOVAL I - REMOVAL PREPARATION OPERATION Shift the selector lever to Neutral. Disconnect the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery). Remove the battery tray (se

 Speed sensor: Removal - Refitting

DP0 Do not drain or remove the automatic gearbox in order to remove the speed sensor. The output speed sensor has been deleted and replaced with wheel speed sensors. REMOVAL I - REMOVAL PREPARATION

 Pressure sensor: Removal - Refitting

DP0 REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on the two-post lift (see 02A, Lifting equipment, Vehicle: Towing and lifting). Disconnect the battery (see 80A, Battery, Batter

SEE MORE:

 Fuel temperature sensor: Removal - Refitting

K9K, and 750 or 752 or 766 or 768 IMPORTANT Use the diagnostic tool before any operation is carried out on the injection circuit to check: that the injector rail is not under pressure, that the fuel temperature is not too high. It is essential to respect the safety and cleanliness advice whenev

 Valves: Adjustment

D4F I - VALVE CLEARANCE ADJUSTMENT PREPARATION OPERATION Fit the vehicle on a two-post lift (see Vehicle: Towing and lifting). Remove: the front right-hand wheel (see Wheel: Removal - Refitting), the front right-hand wheel arch liner (see MR 393 Bodywork, 55A, Exterior protection, Front

© 2016-2025 Copyright Renault Clio Owners Club