Renault Clio: Drive plate: Removal -
Refitting
K4M, and DP0

REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove the gearbox (see Automatic gearbox: Removal - Refitting).
II - OPERATION FOR REMOVAL OF PART
CONCERNED

- Set up the (Mot. 582-01) (2).
- Remove:
- the bolts (2),
- the drive plate,
- tool (Mot. 582-01).
REFITTING
I - REFITTING PREPARATIONS OPERATION
- Check that the drive plate is not damaged (run-out
tolerance of 0.2 mm on the outer diameter).
II - REFITTING OPERATION FOR PART
CONCERNED
- Fit the drive plate, ensuring it is correctly positioned
in relation to the centring pins.
- Apply LOCTITE FRENBLOC to the bolt threads.
- Tighten the bolts on the drive plate.
- Torque and angle tighten the drive plate bolts (55
Nm + 50
READ NEXT:
K9K
Remove the heater plugs (see 13C, Preheating,
Heater plugs: Removal - Refitting, 13C-2).
Disconnect:
the pressure regulation solenoid valve connector (1),
the flow control solenoid val
K4J, and STANDARD HEATING - K4M, and STANDARD HEATING
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
SEE MORE:
K9K, and 772
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions and operation
recommendations before carrying out any
repair:
see Exhaust: Precautions for repair (19B,
Exhaust),
see Vehicle: Precautions for repair (01D,
Mechanical introduction).
Advice on use
In some situations, (air conditioning
off, air recirculation activated, ventilation
speed at zero or low, etc.) you may
notice that condensation starts to form
on the windows and windscreen.
If there is condensation, use the “Clear
View” function to remove it, then use
th
© 2016-2025 Copyright Renault Clio Owners Club
