Renault Clio: Sequential gearbox oil: Specifications
Renault Clio III (2005-2013) Service Manual / Transmission / Sequential Gearbox / Sequential gearbox oil: Specifications
5-SPEED MANUAL SEQUENTIAL GEARBOX
I - GEARBOX TYPE/OIL TYPE CORRELATIONS:
II - STANDARDS AND PART NUMBERS OF THE VARIOUS RECOMMENDED OILS:
Sequential gearbox: Bleeding
I - PROCEDURE
WARNING
- Even a tiny air bubble can cause a malfunction.
- Incorrect bleeding may cause fault finding errors and lead to an unnecessary part replacement.
II - GEARBOX REMOVED
WARNING
When removing the hydraulic clutch tappet, fill the tappet with an approved fluid (see 21B, Sequential gearbox, Sequential gearbox oil: Specifications, 21B-82) before refitting the gearbox, following the procedure described below.
- Fill the reservoir (1) with approved clutch circuit fluid.
- Activate the clutch tappet manually (releasing/engaging the clutch) until releasing/engaging the clutch becomes very difficult, without releasing any air bubbles. If necessary use the fluid (DOT4) to fill the reservoir.
III - GEARBOX IN POSITION
- Drain the reservoir of approved clutch circuit fluid.
- Remove the bleed screw cap.
- Connect a transparent tube to the bleed screw, connected to a syringe with an effective volume of 60 cm3 filled with approved fluid.
- Push the clutch pipe retaining clip and pull the pipe so that it is in the bleed position.
- Slowly inject the fluid in the syringe, making sure that the fluid does not overflow out of the reservoir.
- Carry out the Intake - Reflux operations slowly using the syringe until all of the air bubbles have disappeared.
- Push the pipe back into the retaining clip.
- Perform an auto-bleed using the Diagnostic tool.
- Check that the system is operating correctly by carrying out a road test.
- The level is correct when the fluid is halfway up the reservoir.
Electro-hydraulic unit: List and location of components
D4F, and JA3
- Clutch solenoid valve
- Gear engagement solenoid valve
- Gear engagement solenoid valve
- Selection solenoid valve
- Engagement sensor
- Gear selection sensor
- Solenoid valve unit pressure sensor
- High pressure filter
K9K, and JA5
- Clutch solenoid valve
- Gear engagement solenoid valve
- Gear engagement solenoid valve
- Selection solenoid valve
- Engagement sensor
- Gear selection sensor
- Solenoid valve unit pressure sensor
- High-pressure filter
READ NEXT:
Automatic gearbox: Identification
DP0
The automatic transmission series number can be
found in two places: on a label on the hydraulic distributor
cover (1) and etched onto the outer casing (2) on
the wheel side.
Automatic gearbox oi
Automatic gearbox: Removal - Refitting
K4M, and DP0
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
Remove:
the engine undertray,
the fr
SEE MORE:
Vehicle identification plate
The information shown on the vehicle
identification plate should be
quoted on all correspondence or
orders.
The presence and location of the information
depends on the vehicle.
Vehicle identification plate A
Manufacturer name.
EC design number or approval
number.
Identifi
Electronic stability program
(ESC) with understeer control
and traction control
Electronic stability control ESC
This system helps you to keep control
of the vehicle in critical driving conditions
(avoiding an obstacle, loss of grip
on a bend, etc.).
Operating principle
A sensor in the steering wheel detects
the direction selected by the driver.
Other sensors througho
© 2016-2025 Copyright Renault Clio Owners Club
