Renault Clio: To the rear seat belts
Force limiter
Above a certain severity of impact, this
mechanism is used to limit the force of
the belt against the body so that it is at
an acceptable level.
- Have the entire restraint
system checked following
an accident.
- No operation whatsoever
is permitted on any part of the
system (air bags, electronic control
units, wiring) and the system
components must not be reused
on any other vehicle, even if identical.
- Only qualified personnel from
our Network may work on the air
bags; otherwise the system may
trigger accidentally and cause
injury.
|
READ NEXT:
Side Airbags
This airbag may be fitted to each of the
front seats and is activated at the sides
of the seats (door side) to protect the
occupants in the event of a severe side
impact.
Dep
All of the warnings below are given so that the airbag is not obstructed in
any way when it is inflated and also to prevent
the risk of serious injuries caused by items which may be dislodged when
SEE MORE:
C85 or K85 or S85
REMOVAL
I - REMOVAL PREPARATION OPERATION
C85 or S85
Remove:
the rear wing panel trim (see Rear panel lining:
Removal - Refitting) (71A, Body internal trim),
the rear roof drip moulding trim (see Side roof rail
rear trim: Removal - Refitting) (71A, Body internal
trim),
Tyre pressure monitor: List and location of components
TYRE PRESSURE SENSOR
The system consists of:
four pressure sensors (1) built into the valves (one per
wheel); the sensors transmit a radio signal,
a computer (2) which collects, decodes and processes
sensor signals, and then determines whi
© 2016-2025 Copyright Renault Clio Owners Club
