Renault Clio manuals

Renault Clio: Exhaust gas recirculation: List and location of components

Renault Clio III (2005-2013) Service Manual / Engine And Peripherals / Antipollution / Exhaust gas recirculation: List and location of components

K9K

K9K, and 764 or 766 or 768 or 772

First fitting of the exhaust gas cooler recirculation assembly

Renault Clio. Exhaust gas recirculation: List and location of components

(1) Exhaust gas recirculation solenoid valve
(2) Exhaust gas cooler
(3) Exhaust gas inlet pipe
(4) Metal air inlet tube
(5) Cooler support on the flywheel end
(6) Cooler support on the timing side

Second fitting of the exhaust gas cooler recirculation assembly

Renault Clio. Exhaust gas recirculation: List and location of components

(11) Exhaust gas recirculation solenoid valve
(12) Exhaust gas cooler
(13) Exhaust gas inlet pipe with cooler support, timing end
(14) Cooler support on the flywheel end

K9K, and 750 or 752

Renault Clio. Exhaust gas recirculation: List and location of components

(7) Exhaust gas recirculation solenoid valve
(8) Exhaust gas recirculation mounting
(9) Rigid exhaust gas recirculation pipe
(10) Air inlet metal tube

READ NEXT:

 Exhaust gas recirculation solenoid valve: Removal - Refitting

K9K, and 764 or 766 or 768 REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Disconnect the bat

 Exhaust gas cooler: Removal - Refitting

K9K, and 764 or 766 or 768 or 772 REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Disconnect

 Exhaust gas recirculation unit: Removal - Refitting

K9K, and 750 or 752 REMOVAL Position the vehicle on a two-post lift. Remove the scuttle panel grille (see Scuttle panel grille: Removal - Refitting). Disconnect the exhaust gas recirculation

SEE MORE:

 Pump assembly: Removal - Refitting

K9K, and JA5 REMOVAL I - REMOVAL PREPARATION OPERATION Note: When replacing the electric pump assembly, always replace the control relay. IMPORTANT Before any operation on the sequential system, discharge the accumulator using the Diagnostic tool. To discharge the accumulator, run command " Disc

 Rear Seat Frames And Mechanisms

Single unit rear bench seatback: Removal - Refitting REMOVAL I - REMOVAL PREPARATION OPERATION Remove the single unit rear bench seat base (see 76A, Rear seat frames and mechanisms, Single unit rear bench seat base: Removal - Refitting, 76A-6). II - OPERATION FOR REMOVAL OF PART CONCERNED R

© 2016-2025 Copyright Renault Clio Owners Club