Renault Clio: K4M

Renault Clio. Timing belt: Removal - Refitting

Renault Clio. Timing belt: Removal - Refitting

REMOVAL

I - REMOVAL PREPARATION OPERATION

K4M, and 862

Renault Clio. Timing belt: Removal - Refitting

Renault Clio. Timing belt: Removal - Refitting

II - OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Timing belt: Removal - Refitting

Note: Do not drop the crankshaft timing sprocket when removing the timing belt.

REFITTING - PROCEDURE 1

I - REFITTING PREPARATION OPERATION

II - REFITTING OPERATION FOR PART CONCERNED

1 - Adjusting the timing

WARNING

Be sure to degrease:

This is to avoid timing slippage.

This slippage leads to engine damage.

Renault Clio. Timing belt: Removal - Refitting

Renault Clio. Timing belt: Removal - Refitting

Renault Clio. Timing belt: Removal - Refitting

2 - Refitting

Renault Clio. Timing belt: Removal - Refitting

Renault Clio. Timing belt: Removal - Refitting

Renault Clio. Timing belt: Removal - Refitting

3 - Timing belt tension

Renault Clio. Timing belt: Removal - Refitting

Renault Clio. Timing belt: Removal - Refitting

READ NEXT:

 K9K, and 766 or 768

IMPORTANT Wear protective gloves during the operation. WARNING Never rotate the engine anti-clockwise (timing end). WARNING Do not run the engine without the accessories belt so as not to damage the

 K4J

REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (02A, Lifting equipment). Remove: the scuttle panel grille (see Scuttle pane

 F4R

WARNING Do not run the engine without the accessories belt to avoid damaging the crankshaft accessories pulley. Note: Two different engine support tools can be used to remove the right-hand suspe

SEE MORE:

 Oil vapour rebreathing circuit: Descriptions

K4J or K4M, and 780 or 800 or 801 Oil vapour rebreathing duct Calibrated port Oil vapour recovery plate located on the rocker cover Oil vapour rebreathing hole Oil vapour rebreathing circuit: Operating diagram K4J, and 780 - K4M, and 800 or 801 A: under low loads, the oil vapours are rebr

 Gear control: List and location of components

JH3 or JR5 Press at " A " to separate the gearbox control cables from the anchoring ball joint on the gearbox Press at " B " to separate the gearbox control cables from the sheath stops on the gearbox TL4 Note: The external control of the TL4 gearbox has an adjusting system (3) on the se

© 2016-2025 Copyright Renault Clio Owners Club