Renault Clio: Boot storage
Mobile floor
When fitted to the vehicle, it can be used to make loading easier.
Note: if you need to access the ISOFIX ring and/or the net ring at the bottom of the boot, open flap 3.
| Maximum weight for the mobile floor: 100 kg evenly distributed. |
Movable floor storage
- Lower section 1 onto section 2;
- lift the assembly and position it against the back of the rear bench seat;
- push the catch 4 to lock the mobile floor in the folded position.
Removing the mobile floor
- Lower section 1 onto section 2;
- remove the assembly.
Repositioning the mobile floor
Position it in the boot, using the 5 runners provided.
READ NEXT:
Transporting objects in the boot
Always position the objects transported
so that the largest surface is against:
The rear bench seatback for normal
loads (example A).
The front seatbacks with the rear
seatbacks
Towing, attachments
Permissible nose weight, maximum
permissible towing weight,
braked and unbraked: refer to
the information on “Weights” in
Section 6.
For fitting and conditions of use,
SEE MORE:
Relay shaft bearing: Removal - Refitting
M4R, and TL4
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Disconnect the battery (see Battery: Removal - Refitting)
(MR 392, 80A, Battery).
Remove the front right-hand driveshaft (see 29A,
B-pillar trim: Removal - Refitting
B85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Move the seats fully forward.
Partially remove the frame seals (1).
Partially unclip the front and rear door sill trims.
II - REMOVAL OF PART CONCERNED
Unclip the B-pillar lower trim at (2).
Remove the B-pillar lower trim.
Unclip bolt c
© 2016-2025 Copyright Renault Clio Owners Club
