Renault Clio: Clutch pedal switch: Removal - Refitting

Renault Clio III (2005-2013) Service Manual / Chassis / Mechanical Component Controls / Clutch pedal switch: Removal - Refitting

JH3 or JR5 or TL4, and CRUISE CONTROL - JH3 or JR5 or TL4, and VEHICLE WITH CARD

REMOVAL

I - REMOVAL PREPARATION OPERATION

• Remove:
  • the driver side dashboard lower trim clips (1),
  • the driver side dashboard lower trim (2).

II - OPERATION FOR REMOVAL OF PART CONCERNED

CRUISE CONTROL

• Disconnect the clutch switch connector (3).

• Turn the clutch switch (4) one quarter of a turn anticlockwise.
• Remove the clutch switch (4).

VEHICLE WITH CARD

• Disconnect the clutch switch connector (5).

• Turn the clutch switch (6) one quarter of a turn anticlockwise.
• Remove the clutch switch (6).

REFITTING

I - REFITTING PREPARATION OPERATION

WARNING

To avoid damaging the clutch switch (7) :

• handle the switch with care,
• only activate the piston during the adjustment phase,
• do not perform more than 3 adjustments to dimension (X),
• do not separate the piston from the switch.

Replace the switch:

• if the piston is separated from the switch
• if more than 3 consecutive adjustments to dimension (X) have been performed.

• Measure dimension (X) of the piston (8). If dimension (X) is less than 21 mm, carefully pull on the end of the piston to adjust the dimension (X) between 21 mm minimum and 23 mm maximum.

II - REFITTING OPERATION FOR PART CONCERNED

CRUISE CONTROL

• Depress the clutch pedal by hand.
• Position the clutch pedal on the pedal assembly.
• Lock the clutch switch by turning it a quarter of a turn clockwise.
• At the same time, carefully return the clutch pedal.

Note: The clutch pedal switch has an automatic adjustment feature, adapting to the pedal position.

The automatic adjustment makes a clicking noise when in operation.

• Connect clutch switch connector.

VEHICLE WITH CARD

• Position the clutch pedal on the pedal assembly.
• Lock the clutch switch by turning it a quarter of a turn clockwise.
• Carefully depress the clutch pedal.

Note: The clutch pedal switch has an automatic adjustment feature, adapting to the pedal position.

The automatic adjustment makes a clicking noise when in operation.

• Connect clutch switch connector.

III - FINAL OPERATION.

• Refit the driver side dashboard lower trim.

READ NEXT: