Renault Clio: Drive plate: Removal - Refitting

K4M, and DP0

Renault Clio. Drive plate: Removal - Refitting

REMOVAL

I - REMOVAL PREPARATION OPERATION

II - OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Drive plate: Removal - Refitting

REFITTING

I - REFITTING PREPARATIONS OPERATION

II - REFITTING OPERATION FOR PART CONCERNED

READ NEXT:

 Top And Front Of Engine

 Pressure at end of compression: Check

K9K Remove the heater plugs (see 13C, Preheating, Heater plugs: Removal - Refitting, 13C-2). Disconnect: the pressure regulation solenoid valve connector (1), the flow control solenoid val

 Accessories belt: Removal - Refitting

K4J, and STANDARD HEATING - K4M, and STANDARD HEATING REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (02A, Lifting equipment).

SEE MORE:

 Front door sill lining: Removal - Refitting

B85 or C85 REMOVAL I - REMOVAL PREPARATION OPERATION Partially remove the seal (1). Using a pair of unclipping pliers, unclip the bonnet release catch (2). II - OPERATION FOR REMOVAL OF PART CONCERNED Unclip the trim at (3) and (4). Remove the trim (5). C85 Unclip the trim at (6) and

 Rear wheel arch trim: Removal - Refitting

B85 or C85 IMPORTANT Consult the safety and cleanliness advice and operation recommendations before carrying out any repair (see Airbag and pretensioners: Precautions for the repair) (88C, Airbags and pretensioners). IMPORTANT To avoid any risk of triggering when working on or near a pyrotechnic co

© 2016-2025 Copyright Renault Clio Owners Club