Renault Clio: Engine cooling: Parts and consumables for the repair
Renault Clio III (2005-2013) Service Manual / Engine And Peripherals / Cooling / Engine cooling: Parts and consumables for the repair
INGREDIENT
Coolant GLACEOL RX (TYPE D)
Note: Ready-to-use coolant or antifreeze must be diluted with distilled water in accordance with the guidelines marked on the container.
Engine cooling: Precautions for the repair
IMPORTANT
The circuits are designed to be pressurized, so be careful at high temperatures (risk of serious burns).
Never remove the cap from the expansion bottle while the engine is hot.
Take care when carrying out a repair under the bonnet, as the radiator fan(s) may start to operate without warning.
Do not open the bleed valve(s) while the engine is running.
Only use recommended coolants: GLACEOL RX (TYPE D).
WARNING
- The coolant helps to keep the engine running properly (heat exchange).
- The system does not operate using pure water.
WARNING
Take care not to damage the cooling unit fins (radiator, condenser, etc.) during handling. When carrying out a repair that requires a complete circuit drain, it is essential to flush the circuit with clean water, blow compressed air through the circuit to eliminate water, fill and drain the circuit and then " measure the effective protection " . The parameters to be observed are:
- protection down to - 25
READ NEXT:
Engine cooling system: Check
IMPORTANT
When working in the engine compartment, take
care as the radiator fan(s) may start up unexpectedly
(risk of being cut).
To avoid any risk of serious burns when the engine
is hot:
do not
Engine cooling system: Operating diagram
D4F
D4F, and 740 or 742 or 764
Engine
Cooling radiator
heater matrix
Expansion bottle
Water pump
Thermostat
Bleed screws
5 mm restriction
10 mm restriction
Note:
The rating of the expansio
Cooling system: Draining - Refilling
IMPORTANT
The circuits are designed to be pressurised, so be
careful at high temperatures (risk of serious burns).
Do not remove the cap from the expansion bottle
while the engine is hot.
Take care
SEE MORE:
Boot storage
Mobile floor
When fitted to the vehicle, it can be
used to make loading easier.
Note: if you need to access the ISOFIX
ring and/or the net ring at the bottom of
the boot, open flap 3.
Maximum weight for the mobile
floor: 100 kg evenly distributed.
Movable floor storage
Front end panel: General description
Note:
The information contained in the following
describes the general repair procedure for all vehicles
having the same design for this part.
Before reading the following general information,
make sure that there are no special notes associated
with the vehicle. These special notes are specified
i
