Renault Clio manuals

Renault Clio: Fitting a radio

Renault Clio IV (2014-2019) Owners Manual / Practical advice / Fitting a radio

Radio location 1

Renault Clio. Radio location


Unclip the blanking cover. The aerial, + and – supply and speaker wire connections are located behind it.

Door speakers 2

Renault Clio. Door speakers


To install any equipment, please consult an authorised dealer.

  • In all cases, it is very important to follow the manufacturer’s instructions carefully.
  • The specifications of the brackets and wires (available from our network) vary depending on the equipment level of your vehicle and the type of radio.

    Consult an approved Dealer to find out the correct part number.

  • No work may be carried out on the vehicle’s electrical or radio circuits, except by approved dealers: an incorrectly connected system may result in damage being caused to the electrical equipment and/or the components connected to it.

READ NEXT:

 Accessories

Electrical and electronic accessoriesBefore installing this type of accessory (particularly for transmitters/receivers: frequency bandwidth, power level, position of the aerial, etc.

 Wipers (replacing blades)

Replacing windscreen wiper blades 1 With the ignition off, lift wiper arm 2; turn blade 1. Lower tab 3, by pressing on either side A. Then push the blade forwards B, to release

 Towing

Before towing, unlock the steering column: with the clutch depressed, engage first gear (lever in position N or R for vehicles with automatic gearboxes), insert the RENAULT card in the card reade

SEE MORE:

 Oil pressure sensor: Removal - Refitting

D4F, and 740 or 742 or 764 REMOVAL I - REMOVAL PREPARATION OPERATION Put the vehicle on a two-post lift (see Vehicle: Towing and lifting). Disconnect the battery (see Battery: Removal - Refitting). Remove the engine undertray. Unclip the connector cover (1). Remove the oil pressure sensor

 Fuel vapour recirculation circuit: Function

D4F or F4R or K4J or K4M or M4R WARNING The breather must not be blocked during normal engine operation. The tank is vented through the fuel vapour absorber. Fuel vapour is trapped by the active carbon contained in the absorber as it passes through. Fuel vapour trapped in the absorber is eliminate

© 2016-2025 Copyright Renault Clio Owners Club