Renault Clio: Front side door trim: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove the front speaker (see Front speakers:
Removal - Refitting) (MR 392, 86A, Radio).

- Unclip the door mirror trim piece (1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED

- Use a flat-blade screwdriver to undo the trim piece (2).


- Remove trim and bolt.
- Take out interior handle (4) (depending on equipment
level).
- Disconnect the supply connectors.
Note:
For vehicles fitted with manual window winders,
protect the door trim and remove the winder handle
using an unclipping tool.


- Remove the bolts (6).
- Unclip:
- trim using a pair of unclipping pliers (protect the
door box section),
- the interior door handle cable using a flat-blade
screwdriver.
- Disconnect the supply connectors.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
- Reconnect the supply connectors.
- Reclip:
- the interior door handle cable,
- the door trim.




- Reconnect the supply connector.
- Reclip the trim piece (10).
II - FINAL OPERATION
- Refit the front speaker (see Front speakers: Removal
- Refitting) (MR 392, 86A, Radio).

- Reclip:
- the door mirror trim piece (11),
- window winder handle (if fitted in vehicle).
- Carry out a function test.
READ NEXT:
B85 or K85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Special features of vehicles fitted with manual
window winders
Unclip the winder handle (1) using a pair of unclipping
pliers (protect the door
WITHOUT SPORT SEATS, and DOCUMENTATION PHASE 2
IMPORTANT
Before beginning work on any component of the
safety system, it is essential to lock the airbag computer
using the Diagnostic tool (see Airbag
SEE MORE:
D4F or K4J or K4M or M4R
IMPORTANT
During this operation, be sure to:
be careful of fuel splashes when disconnecting the
union.
IMPORTANT
Wear goggles with side protectors for this operation.
IMPORTANT
Wear leaktight gloves (Nitrile type) for this operation.
WARNING
To avoid any corrosion or da
DP0 or JH3 or JR5 or TL4
Tightening clip
Tightening ring
Cup
Driveshaft yoke sleeve
Deflector
Propeller shaft
RC gaiter
Spider
Lock ring
Spring
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting eq
© 2016-2025 Copyright Renault Clio Owners Club
