Renault Clio: Radiator mounting cross member: General description
Renault Clio III (2005-2013) Service Manual / Panelwork / Front Lower Structure / Radiator mounting cross member: General description
Note: The information contained in the following describes the general repair procedure for all vehicles having the same design for this part.
Before reading this general information, check that there are no special notes associated with this vehicle.
These special notes will be specified if applicable in other parts of this subsection dealing with the part.
Note: For a detailed description of a particular connection, see MR 400.
DESIGN OF THE STRUCTURAL COMPONENT
This steel part, which bolts onto the front axle subframe, combines two functions:
- distribution of front impact forces,
- radiator support cross member.
Radiator mounting cross member: Removal - Refitting
I - REMOVAL
1 - REMOVAL PREPARATION OPERATION
- Remove the front bumper (see Front bumper: Removal - Refitting).
- Attach the radiator upper section.
- Remove the engine undertray.
2 - OPERATION FOR REMOVAL OF PART CONCERNED
- Remove the mounting bolts (1) from each side.
- Remove the mounting bolt (2) from each side.
II - REFITTING
1 - REFITTING OPERATION FOR PART CONCERNED
- Refit the mounting bolts (1) and (2).
- Torque tighten the
- the mounting bolts (1) (21 Nm),
- mounting bolts (2) (105 Nm).
2 - FINAL OPERATION
- Refit the engine undertray.
- Detach the radiator upper section.
- Refit the front bumper (see Front bumper: Removal - Refitting).
READ NEXT:
Front side member: General description
IMPORTANT
Use a repair bench to ensure the positioning of the
points and the geometry of the axle assemblies.
Note:
The information contained in the following
describes the general repair procedure fo
Front side member, centre section: General description
IMPORTANT
Use a repair bench to ensure the positioning of the
points and the geometry of the axle assemblies.
Note:
The information contained in the following
describes the general repair procedure fo
Front side member closure panel, front section:
General description
IMPORTANT
Use a repair bench to ensure the positioning of the
points and the geometry of the axle assemblies.
Note:
The information contained in the following
describes the general repair procedure fo
SEE MORE:
Turbocharging: Precautions for the repair
D4F or K9K
I - TURBOCHARGER: GENERAL INSTRUCTIONS
For the turbocharging pressure regulator check (see
Fault finding - Tests) (Technical Note 3419A, 12B,
Turbocharging).
WARNING
The turbocharger pressure regulator rod must not
be adjusted.
II - TURBOCHARGER CIRCUIT DIAGRAM
Air filter unit
Air fl
Oil level sensor: Removal -
Refitting
D4F, and 740 or 742 or 764
REMOVAL
I - REMOVAL PREPARATION OPERATION
Disconnect the battery (see Battery: Removal - Refitting)
(MR 392, 80A, Battery).
Move the air inlet hose to one side.
Disconnect the connector from the oil level sensor.
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Rem
