Renault Clio: Engine coolant
With the engine switched off and on level ground, the level when cold must be between the MINI and MAXI marks on reservoir 1.
Top this level up when cold before it reaches the MINI mark.
| When working in the engine
compartment, ensure that
the windscreen wiper stalk
is in the park position. Risk of injury. |
Frequency of checking coolant level
Check the coolant level regularly (very severe damage is likely to be caused to the engine if it runs out of coolant).
If the level needs to be topped up, only use products approved by our Technical Department which ensure:
- protection against freezing;
- an anti-corrosion protection for the cooling system.
| Before performing any action in the engine compartment, the ignition must be switched off by pressing the engine stop button (please see the information on “Starting, stopping the engine” in Section 2). |
Replacement interval
Refer to the Maintenance Document for your vehicle.
| Consult your approved dealer at once if you notice an abnormal or repeated drop in any of the fluid levels. |
| No operations should be
carried out on the cooling
circuit when the engine is
hot. Risk of burns. |
READ NEXT:
Brake fluid
The level should be read with the engine
switched off and on level ground.
This should be checked frequently,
and immediately if you notice even the
slightest loss in braking efficiency.
Windscreen washer reservoir
Topping up
With the engine switched off, open the
cap 3. Fill until you can see the fluid,
then replace the cap.
Liquid
Screen wash product (product with
antifreeze in winter).
Filters
The replacement of filter components
(air filter, cabin filter, diesel filter, etc.)
is scheduled in the maintenance operations
for your vehicle.
Replacement intervals for filter elements:
refe
SEE MORE:
Injector rail - Injectors: Removal - Refitting
D4F, and 740 or 742 or 764
REMOVAL
I - REMOVAL PREPARATION OPERATION
Disconnect the battery (see Battery: Removal - Refitting).
Remove:
the air filter box (see 12A, Fuel mixture, Air filter unit: Removal
- Refitting, 12A-17),
the intake distributor (see 12A, Fuel mixture, Inlet distributor
Rear drum bearing: Removal - Refitting
Using a dial gauge connected to the drum, check that
the end float is greater than 0.03 mm.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle: Towing and
lifting).
Remove:
the rear wheels (see 35A, Wheels and tyres,
Wheel: Removal - Refitting, 35
© 2016-2025 Copyright Renault Clio Owners Club
