Renault Clio: Exhaust: List and location of components
Renault Clio III (2005-2013) Service Manual / Engine And Peripherals / Exhaust / Exhaust: List and location of components
PIPE ASSEMBLY
D4F, and 740 or 742 or 764
(ZC1) cutting area between the catalytic
converter and the expansion
chamber
(ZC2) cutting area between the expansion
chamber and the silencer
D4F, and 784 or 786
(ZC1) cutting area between the expansion chamber and the silencer
K4J
(ZC1) cutting area between the catalytic
converter and the expansion
chamber
(ZC2) cutting area between the expansion
chamber and the silencer
K4M
(ZC1) cutting area between the catalytic
converter and the expansion
chamber
(ZC2) cutting area between the expansion
chamber and the silencer
M4R
(ZC1) cutting area between the catalytic
converter and the expansion
chamber
(ZC2) cutting area between the expansion
chamber and the silencer
F4R
(ZC1) cutting area between the catalytic
converter integrated into the
exhaust pipe and the expansion
chamber
(ZC2) cutting area between the expansion
chamber and the silencer
K9K, and 764
(ZC1) cutting area between the expansion
chamber inlet pipe and the
expansion chamber
(ZC2) cutting area between the expansion
chamber and the silencer
K9K, and 750 or 752 or 760 or 762 or 766 or 768
(ZC1) cutting area between the intermediate
pipe inlet pipe and the
intermediate pipe
(ZC2) cutting area between the intermediate
pipe and the silencer
K9K, and 772
(ZC1) cutting area between the particle
filter and the intermediate pipe
(ZC2) cutting area between the intermediate
pipe and the silencer
READ NEXT:
Exhaust: Precautions for the repair
I - PARTS AND CONSUMABLES FOR THE REPAIR
1 - Parts always to be replaced:
the exhaust trunking (if fitted)
the seal or sealing ring on the connection between the
catalytic converter or catalytic
Catalytic pre-converter: Removal - Refitting
K9K, and 772
PARTS AND CONSUMABLES FOR THE
REPAIR WORK
Parts always to be replaced:
the seal between the catalytic pre-converter and
the turbocharger,
the seal between the catalytic pre-conve
Catalytic converter: Removal - Refitting
K4J or K4M
IMPORTANT
Catalytic converters contain ceramic fibres: these
are contained within a closed unit, and cannot disperse.
Cutting or drilling catalytic converters is prohibited.
REMOVAL
I - R
SEE MORE:
Rear light bulb: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the rear light on the wing (see 81A, Rear
lighting, Rear wing light: Removal - Refitting, 81A-5).
B85 or C85 or S85, and DOCUMENTATION
PHASE 1
Unclip the bulb holder plate (1) by pressing clips (2) and (3).
K85, and DOCUMENTATION PHASE 1
Un
Fuel flow: Check
D4F or K4J or K4M or M4R
IMPORTANT
During this operation, be sure to:
be careful of fuel splashes when disconnecting the
union.
IMPORTANT
Wear goggles with side protectors for this operation.
IMPORTANT
Wear leaktight gloves (Nitrile type) for this operation.
WARNING
To avoid any corrosion or da
