Renault Clio: Rear brake hose: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Chassis / Rear Axle Components / Rear brake hose: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment).
WARNING
Prepare for brake fluid outflow, to prevent damage to the mechanical parts and bodywork around the braking system.
- Fit the pedal press to the brake pedal to limit the outflow of brake fluid.
II - OPERATION FOR REMOVAL OF PART CONCERNED
- Remove:
- the unions (1) from the pipe concerned,
- the pipe concerned.
REFITTING
I - REFITTING PREPARATIONS OPERATION
WARNING
Do not twist the brake hose.
Make sure that there is no contact between the brake hose and the surrounding components.
II - REFITTING OPERATION FOR PART CONCERNED
- Refit the hose.
- Torque tighten the brake hose unions (14 Nm).
III - FINAL OPERATION.
- Remove the pedal press from the brake pedal.
- Bleed the brake circuit (see 30A, General information, Braking circuit: Bleed, 30A-4).
- Check the brake fluid level.
READ NEXT:
Rear brake calliper: Repair
WARNING
Prepare for the flow of fluid, and protect the surrounding
components.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (
Rear brake calliper: Removal - Refitting
Note:
The callipers supplied as replacement parts are
pre-filled.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle: Towing and
lifting).
WARNING
Pre
Rear brake calliper mounting: Removal - Refitting
DISC BRAKE
REMOVAL
I - REMOVAL PREPARATION OPERATION
Put the vehicle on a two-post lift (see Vehicle: Towing and lifting).
Remove:
the rear wheels (see 35A, Wheels and tyres,
Wheel: Removal -
SEE MORE:
Accelerator pedal: Removal - Refitting
VERSION WITHOUT ADAPTATION SUPPLEMENT
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the retaining clips on the driver side dashboard
lower trim,
the driver side dashboard lower trim.
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Disconnect the accelerator pedal potentiometer con
Driveshaft: Precautions for the repair
DP0 or JH3 or JR5 or TL4
WARNING
A gearbox oil leak at the driveshaft may destroy it.
WARNING
Always replace seals whenever the driveshaft is
removed.
WARNING
Grease the base of the bearing using BR 2 +
grease to prevent the bearing from sticking.
Make sure that the O-ring is correctly positioned i
© 2016-2025 Copyright Renault Clio Owners Club
