Renault Clio: Windscreen pillar trim: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Trim And Upholstery / Body Internal Trim / Windscreen pillar trim: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Partially remove the seal (1).
II - OPERATION FOR REMOVAL OF PART CONCERNED
- Unclip the top of the pillar trim at (2).
- remove the pillar trim by pulling upwards.
REFITTING
I - REFITTING PREPARATIONS OPERATION
- Check the condition of the clips (3).
II - REFITTING OPERATION FOR PART CONCERNED
- Refit the trim starting from the bottom.
III - FINAL OPERATION.
- Refit the seal (4).
Side roof rail rear trim: Removal - Refitting
C85 or S85
REMOVAL
OPERATION FOR REMOVAL OF PART CONCERNED
- Unclip the rear roof drip moulding lining.
REFITTING
REFITTING OPERATION FOR PART CONCERNED
- Refit the rear roof drip moulding lining.
READ NEXT:
B-pillar upper trim: Removal - Refitting
C85
REMOVAL
REMOVAL PREPARATION OPERATION
Remove:
the complete rear bench seat,
the rear wing panel lining (see 71A, Body internal
trim, Rear panel lining: Removal - Refitting, 71A-32).
B-pillar trim: Removal - Refitting
B85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Move the seats fully forward.
Partially remove the frame seals (1).
Partially unclip the front and rear door sill trims.
II - REMOVAL OF PART CONCE
Rear inner sill upper trim: Removal - Refitting
B85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the complete rear bench seat.
Partially remove seal (1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Remove the trim at (2) and at (3).
SEE MORE:
Rear right-hand side door wiring: Removal - Refitting
B85 or K85
IMPORTANT
Consult the safety and cleanliness advice and operation
recommendations before carrying out any
repair (see 88A, Wiring harness, Wiring: Precautions
for the repair, 88A-5).
REMOVAL
I - REMOVAL PREPARATION OPERATION
Raise the window fully.
Switch off the ignition.
Disconnect
Fuel circuit: Operating diagram
D4F or F4R or K4J or K4M
Operating diagram of the petrol supply circuit ( " pump - sender - fuel
filter " assembly).
The fuel system does not have a return.
The fuel pressure does not vary with engine load.
The circuit comprises:
a rail (1) without a return pipe union and without a
supply pre
© 2016-2025 Copyright Renault Clio Owners Club
