Renault Clio: Crankshaft position sensor: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Engine And Peripherals / Diesel Injection / Crankshaft position sensor: Removal - Refitting
K9K, and 764 or 766 or 768
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Position the vehicle on a two-post lift (see Vehicle: Towing and lifting).
- Disconnect the battery (see Battery: Removal - Refitting).
- Remove the engine undertray.
II - OPERATION FOR REMOVAL OF PART CONCERNED
- Disconnect the connector (1) from the engine speed and position sensor.
- Remove the engine speed and position sensor (2).
REFITTING
I - REFITTING OPERATION FOR PART CONCERNED
- Refit the engine speed and position sensor.
- Connect the engine speed and position sensor connector.
II - FINAL OPERATION
- Refit the engine undertray.
- Connect the battery (see Battery: Removal - Refitting).
K9K, and 750 or 752
REMOVAL
I - REMOVAL PREPARATION OPERATION
- Remove the air filter unit air inlet pipe.
II - OPERATION FOR REMOVAL OF PART CONCERNED
- Disconnect the connector (1) from the engine speed and position sensor.
- Remove:
- the engine speed and position sensor bolts (2),
- the engine speed and position sensor.
REFITTING
I - REFITTING OPERATION FOR PART CONCERNED
- Refit:
- the speed and position sensor,
- the engine speed and position sensor bolts.
- Connect the engine speed and position sensor connector.
II - FINAL OPERATION
- Refit the air filter unit air inlet pipe.
READ NEXT:
Pre-postheating unit: Removal - Refitting
K9K
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the battery (see Battery: Removal - Refitting),
the battery tray (see Battery tray: Removal - Refitting)
(MR 392, 80A, Battery).
II
Heater plugs: Removal - Refitting
K9K, and 764 or 772
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the air filter box inlet air pipe (1).
Remove the turbocharger outlet air pipe retaining pins (2).
Remove:
the turbochar
SEE MORE:
3rd brake light: Removal - Refitting
B85 or C85 or S85
REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED
Remove the blanking covers (1).
Insert a screwdriver in the openings to move the clips (2).
Apply pressure to the clips (2) to unclip the high level
brake light.
Partially remove the raised brake light using a flat-blade
Air filter unit: Removal - Refitting
D4F, and 740 or 742 or 764
REMOVAL
I - REMOVAL PREPARATION OPERATION
Apply pressure to (1).
Pull at (2).
Remove the air breather sleeve (3) from the front
end panel.
Undo the clip (4) mounting the air filter unit to the
motorised throttle valve.
Disconnect the oil vapour rebreathing hose
© 2016-2025 Copyright Renault Clio Owners Club
